APM 2.6 Set(External Compass)+Ublox NEO-6M GPS+APM Power XT60 Description: Side Pin Case APM 2.6 Set(External Compass)+Ublox NEO-6M GPS+APM Power XT60 Description: The APM 2.6 is a complete open source autopilot system and the bestselling technology that won the prestigious 2012 Outback Challenge UAV competition. It allows the user to turn any fixed, rotary wing or multirotor vehicle (even cars and boats) into a fully autonomous vehicle; capable of performing programmed GPS missions with waypoints. Available with top or side connectors.A This revision of the board has no onboard compass, which is designed for vehicles (especially multicopters and rovers) where the compass should be placed as far from power and motor sources as possible to avoid magnetic interference. (On fixed wing aircraft it's often easier to mount APM far enough away from the motors and ESCs to avoid magnetic interference, so this is not as critical, but APM 2.6 gives more flexibility in that positioning and is a good choice for them, too). This is designed to be used with the 3DR uBlox GPS with Compass (see option below), so that the GPS/Compass unit can be mounted further from noise sources than APM itself.A APM 2.6 requires a GPS unit with an onboard compass for full autonomy. If you are using APM 2.6 with a GPS module that does not have a compass sensor, you must use a stand-alone external compass.A A Features: Arduino Compatible! Can be ordered with top entry pins for attaching connectors vertically Includes 3-axis gyro, accelerometer andA magnetometer, along with a high-performance barometer Onboard 4 MegaByte Dataflash chip for automatic datalogging Optional off-board GPS, uBlox LEA-6H module with Compass. One of the first open source autopilot systems to use Invensense's 6 DoF Accelerometer/Gyro MPU-6000. Barometric pressure sensor upgraded to MS5611-01BA03, from Measurement Specialties. Atmel's ATMEGA2560 and ATMEGA32U-2 chips for processing and usb functions respectively APM Power: The APM 2.5 Power Module is a simple way of providing your APM 2.5 with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6-pos cable. The on-board switching regulator outputs 5.3V and a maximum of 2.25A from up to a 4S LiPo battery. The Power Module comes completely assembled with Deans connectors, and wrapped in shrink tubing for protection.A Note: The Power Module is only designed to power APM, a RC receiver and APM accessories (GPS, 3DR radio). It is not designed to power servos. Use your aircraft's own ESC/BEC for that. Specifications: Max input voltage: 18VA Max current sensing: 90A -A Voltage and current measurement configured for 5V ADCA Switching regulator outputs 5.3V and 2.25A maxA 6-pos DF13 cable plugs directly to APM 2.5's 'PM' connector A Package includes: APM 2.6 main board APM plastic case APM NEO-6M GPS Module APM Power module XT60 kit(include 5V modulei 1/4 ? Power Cable USB Cable I2C Cable Shipping & Payment: Here Offer 100% Satifiation Service,Inlucde re-send item&refund payment; All items here offer 1 year warranty It is not my Duty for Custom Tax All items will be shipped via int'l air mail( no tracking number for items under $50), the time normally takes 7-15 business days. may be later arrivel if the item is checked by custom; We only accept paypal payment.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.
