counterbore cutter tool for sale, brand-new and used.

1 7/32" SPOT FACER COUNTERSINK HIGH SPEED TAPER SHANK COUNTERBORE AND SPOT FACER FOR INTERCHANGABLE PILOTS 1 7/32" DIA WITH TAPER SHANK 5 FLUTE CUTTER 3/8 PILOT HOLE 5/32 WRENCH USED IN EXCELLENT CONDITION PLEASE SEE ALL PICTURES FOR DETAILS THANKS FOR LOOKING PLEASE SEE MY OTHER LISTING FOR MORE

CLEVELAND TWIST 20719 HIGH SPEED TAPER SHANK COUNTERBORE AND SPOT FACER FOR INTERCHANGABLE PILOTS 1 1/16" DIA WITH TAPER SHANK 3 FLUTE CUTTER USED IN EXCELLENT CONDITION PLEASE SEE ALL PICTURES FOR DETAILS THANKS FOR LOOKING PLEASE SEE MY OTHER LISTING FOR MORE GAGES AND MACHINIST TOOLING Check out my other

CLEVELAND TWIST W7189 HIGH SPEED TAPER SHANK COUNTERBORE AND SPOT FACER FOR INTERCHANGABLE PILOTS 1 3/4" TAPER SHANK 5 FLUTE CUTTER 7/16 PILOT HOLE USE 5/32 WRENCH USED IN EXCELLENT CONDITION I HAVE QUANTITIES IN CASE YOU WANT MORE THAN ONE PLEASE SEE ALL PICTURES FOR DETAILS THANKS FOR LOOKING

CLEVELAND TWIST S75 HIGH SPEED TAPER SHANK COUNTERBORE AND SPOT FACER FOR INTERCHANGABLE PILOTS 1 11/16" DIA WITH TAPER SHANK 5 FLUTE CUTTER 7/16 PILOT HOLE 5/32 WRENCH USED IN EXCELLENT CONDITION PLEASE SEE ALL PICTURES FOR DETAILS THANKS FOR LOOKING PLEASE SEE MY OTHER LISTING FOR MORE GAGES AN

This is for One very nice used counter sink/counterbore tool holder without any cutters for it. 5mt shank This one does have the snap ring up inside it. I believe it helps to keep the cutter from falling out if your spindle stops too fast but it is not necessary for using it.

This is for One Good used counter sink/counterbore tool holder 1mt. This one does not have the snap ring up inside it. I believe it helps to keep the cutter from falling out if your spindle stops too fast but it is not necessary for using it.

LIST K-33 EDP 50033 SPLINE TAPER DRIVE 1/2" HOLE STAN-HI MANUFACTURER: STANDARD TOOL CO. - CLEVELAND OHIO -. VERY HARD TO FIND ITEM NO LONGER MADE STILL IN ORIGINAL BOX.

Description: 1pcs 4 Flutes HSS AL Counterbore Cutter tool 5.2x8.9mm M5 Specification: Cutting dia: 8.9mm Shank dia: 8 mm OAL:&nb

STANDARD TOOL COUNTERBORE 2.612"" DIAMETER CUTTER 4 FLUTE 1 5/16" CUTTER HEIGHT COMPLETE WITH 2.030" PLUG TAPERED SHAFT 1 1/4" MAJOR DIAMETER USED IN EXCELLENT CONDITION PLEASE SEE ALL PICTURES FOR DETAILS THANKS FOR LOOKING PLEASE CHECK OUT MY OTHER LISTINGS FOR MORE GAGES AND MACHINE TOOLING

This is a nice used master holder for holding cutters that have the Devlieg hex drive shank, Gairing also makes this same system but I am not sure if they are interchangeable. It is equipped with 3 cutters. The hex shank measures about .744" across the Flats.

This is a nice used master holder for holding cutters that have the Devlieg hex drive shank, Gairing also makes this same system but I am not sure if they are interchangeable. It is equipped with 2 cutters. The hex shank measures about .744" across the Flats.