d flange motor for sale, brand-new and used.

12 volt D.C. MOTOR permanent magnet powerful magnets You are bidding on one 3 hp electric motor - 3 hp at 13.6 VOLT D.C.

Zoeller Model X160 High Head Effluent Pump Description This series of submersible pumps is designed for use in residential or commercial dewatering and effluent applications in Class I, Division 1, Group C and D environments. Each pump is FM/CSA approved and features innovative motor and electrical enclosures that are designed to reduce the risk of vapor ignition both inside and outside the pump.

[ Dayton 30 In Dia 3 HP 200-230/460V Tubeaxial Fan

You are considering a Brook Crompton, Inverter Duty Electric Motor. This motor is believed to be unused surplus, in its original packaging. Packaging was open when we received this motor, and the motor body has several spots where the paint is chipped (mostly on edges of conduit box and mounting flange).

You are bidding on a NEW Square-D 8538SBA23V02S Combo Motor Starter Fused Switch 3Pole 30Amp 120VCoil NEW. Also included are 3 new TRS30R 30 Amp fuses. See photos for more info and specs.

Greenlee Gator Plus EK 22GL lightly used

J. Little Mercer Co., Inc. B-3967

MKS Assy: 653B-3-80-1, Jalepeno Valve, Nupro, 5 ea TC's & MKS Htr Jackets, HTD 1. MKS 653B-3-80-1 Exhaust Throttle valve controller with high speed motor/gear assembly: ISO NW80 Flange Nominal ID in inches: 2.88 (73mm) Flapper O-Ring 2.

CAT/Olympian 75KW Diesel Generator Model#: D75P1S Serial: E6963B/001 Excellent Condition 32 Hours run time Weatherproof enclosure. Unit has been checked over and all hoses and block heater replaced. All filters and fluids have been serviced/replaced.

dynamic microphone 600ohm impedance cannon type connector, CONDITION: NEW , MICROPHONE ONLY SENSITIVITY -77DBFREQUENCY RESPONSE: 60-17000hz(-8DB)ON/OFF SWTICHUNI-DIRECTIONALMicrophone wire (approximately 3m = 10 feet)INTERNAL CODE(item location, box E)

These were purchased as samples for a project that did not take off, and they have been sitting in our parts room. They are in good, like new, condition. Here is specs on them: Disp.ment = 3.5 Max Pressure= P1 250, P2 270, P3 290 Max Speed = 5000 Min.

DELCO ELECTRIC MOTOR - 75HP, 1800 RPM, TEFC, 444 UC FRAME 444 UC FRAME, FOOT MOUNTED, (NOS) 460V, 3PH, WEIGHT 1450 LBS BUYER PAYS SHIPPING FROM TROY, MI. 48083 OTHER "C" FACE AND "D" FLANGE MODELS AVAILABLE ANY ADDITIONAL INFORMATION CONTACT PHIL@248-8401860

Unused...US Motors. 1hp. 1755RPM.

Metric Speed Reducer, Nominal Output Speed 115 Revolutions per Minute, Overhung Load 2200 Pounds, Nominal Ratio 15:1, Maximum Torque 4157 Inch Pounds, Output Torque @ 7.5 HP 3767 Inch Pounds, Worm Center Distance 108 Millimeters, IEC Motor Frame 132, Solid Output Shaft, D Flange, Right Angle.

I am offering a Dayton Tubeaxial Fan 26-7/8 In. W 37-1/4 In. H .

I am offering a Dayton Tubeaxial Fan 26-7/8 In. W 37-1/4 In. H .

The picture below is a stock photo. This is what the item looked like before the squirrel cage had some dents and was all scratched up... so it was thrown out.