fairbanks cart for sale, brand-new and used.

Burndy BT06EC10-6P, MS3116F10-6P, 6 pin Male Connector, with hood & cable clamp Connection type: Fixed pins with solder cups These connectors arer New Old Stock, packaged in original factory sealed bags. NOTE: Please compare this item with similar items from other sellers. We are sure you will find that our prices are reasonable, and our shipping charges are not inflated.

This is a set of (4) ANTIQUE CAST IRON "THE FAIRBANKS CO" CASTER CART WHEELS ~ (2) SWIVEL. EMBOSSED 4M - 4". All wheels turn freely.

This is an Old Briggs & Stratton Gas Engine. Model R2 and Serial 2162. Good Compression and Spark.

used 1P3T Rotary Switch, 3 position, 1/4 inch shaft, 3/8" mount bushing Solder terminals. Wafer material: ceramic. As presently configured, the outer wafer serves only as a terminal block for two 20K 2 watt resistors and one 610 ohm 1/2 watt resistor.

used 3P3T Rotary Switch, 3 position, 1/4 inch shaft, 3/8" mount bushing Solder terminals. Manufacturer unknown. Mounting hole: 3/8 inch diameter.

111SD, used 4P3T (or 4P5T) Rotary Switch, 3 or 5 position, 1/8" shaft, 1/4" mount bushing There are two rotation stop tabs. As presently configured, the 3 position stop tab is in place (and the 5 position stop tab is bent out of the way). To reconfigure for 5 positions: bend the 3 position tab out of the way, and bend the 5 position tab down (toward the wafters).

PA300, used 5P3T Rotary Switch, 3 position, 1/4 inch shaft, 3/8" mount bushing Solder terminals. Wafer material: ceramic. Manufacturer unknown.

PA1007, used 3P3T Rotary Switch, 3 position, 1/4 inch shaft, 3/8" mount bushing Solder terminals Manufacturer unknown. Mounting hole: 3/8 inch diameter. Threaded bushing is 3/8 inch long.

2 Equipment Case Enclosure Black Plastic Handles, 5 3/16" x 1-3/16"- some damage These handles are made of tough slightly flexible plastic. One is ready to go, as is. The other might be usable for light duty, with some TLC.

Fairbanks model 9292-HC (Ref. Grainger 18F478 for item specifics) 30 - 55 gallon 1000 pound capacity barrel or drum hand cart. Very well made heavy duty all welded construction with two 10" X 2-1/2" rubber over solid cast steel wheels with ball bearings and grease fittings and it has a kick stand for holding or storing it upright.

TWO with Ball-Bearing swivels,& TWO stationary mounted wheels...7 1/2" tall with 4 5/8 x 3 7/8" base.. Holes measure 3 to 3 1/2" center to center, with slotted lead-way for adjustment. .

Here`s a nicely restored 1930 Fairbanks Morse Z engine on a wooden cart belted to a Myers pumpjack and an early brass water pump, all running and show-ready. The previous owner had restored it and put this combination together to set up at engine shows with it. The only issues are that the FM doesn`t have the correct fuel tank and there`s a soldered crack on the lower section of the pump, but it works well.

Sold as is, it is missing pieces I am not sure which ones. Sold with the cart it has been attached to. Local Pickup.