For 60w Supply Laser Co2 Cutting Power Cutter Engraving Engraver

US $230.21

  • Shanghai, China
  • Jan 30th
POWER FOR ENGRAVING 60W ENGRAVER CO2 LASER CUTTING SUPPLY CUTTER TENSION 1.5 DUAL POINTER DIAL N GAUGE METER FORCE 2*YZ2515X TYPE BT100FJ DISPENSING PERISTALTIC PUMP & NEW PH LCD METER ELECTRODES TESTER PHSJ-3F PH/MV/TEMPERATURE DIGITAL FLUORESCENCE QUARTZ CUVETTE 10 MM WITH PTFE COVER 1PC   Features: 1. High response speed, Dramatically lengthen the life of laser. 2. Easy control: The start and stop of laser can be easily controlled by TTL level. And there are protection switch to test the external water, ventilation, etc. 3. Easy control of laser power: Both 0 - 5V analog signal and PWM signal can control the laser power. 4. The power supply has open circuit protection: Under the condition of good protective earthing, the power supply can work in open-circuit for a short time, which could avoid the damage of laser power supply because of the bursting of laser tube, thereby enhancing the life of power supply. 5. The power supply can take feedback interface which can be used in closed-loop control and testing the working current of laser. 6. Application: Acrylic sculpture, cut; fabric sculpture, cut; rubber sheet sculpture, cut; etc.   Technical parameters: AC Input Voltage AC 220V AC frequency 50HZ Maximum Output voltage 35 KV Maximum current 23 mA ( up to the laser tube) Efficiency 91% Overcurrent protection  130% of the Maximum current Open circuit protection  Support (short) Cooling way  Force-air Cooling(FAC) High level control voltage range >=3V Low level control voltage range

Directions

Similar products from Laser Modules

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies