forklift cylinder for sale, brand-new and used.

Up for sale is a 5x48 Prince tie rod hydraulic cylinder in new condition. These have been in storage for a while and do have scratches and scuffs but have never been used. Local pick up is preferred.

MECO Cylinder Pallet Rack -6-cylinder capacity. Store cylinders and efficiently move them with your forklift. For 9" diameter Cylinders that are separated by hinged dividers Fork pockets: 6-1/4" W19-3/4" clearance is required between forks Constructed of 7-gauge steel All welded I will prepare for shipping or you can pickup.

Howmet Hot Stamp Machine with Table & Spare Air Cylinder Howmet Roll-Leaf Division, Model D, serial no. 87, equipped with an AHP-42-A-L tape feeder The table it is mounted on is included, as well as a spare air cylinder & misc. foil Air-powered (min.

This is a NIB Sauer Danfoss TMTW-500 hydraulic motor. Specs below: TMTW 500 151Z3277 500cc Displacement 250 Max RPM Continuous 300 Max RPM Interval 2390 Nm Peak Torque 56 HP Max Output See more in photos. Several available, message for details on multiple sale.

Available Now...... Clark C500-135 13,500LB Capacity LP/Propane ( Tank is NOT included) Cushion Tires 54" Forks 130" Two stage mast 18" Free lift New seat New master cylinder New LP lines

33.5# Liquid w/gauge - Fills through vapor opening

Allis Chalmers 4350 pound lift forklift, a little on the old ugly side but runs fine. This unit comes with a 4 cylinder gas engine, it has a lift height of 174 inches and the mast has a down height of 6 feet which makes it ideal for a small shop with low doors. This forklift is ready to go to work.

TCM 4000 pound lift forklift in excellent running condition. This unit comes with a Nissan 4 cylinder propane engine, it has a lift height of 145.3 inches and the mast has a down height of 6 feet which makes it ideal for a small shop with low doors. This forklift is job ready.

JCB model 510-40 4x4x4 10K 40 foot reach forklift in excellent condition, the hour meter shows 7600 hours. This unit comes with a 4 cylinder Perkins diesel engine, fork and carriage tilt and hydraulic stabilizers. This forklift is job ready.

Pertronix electronic ignition conversion for 4-cylinder Mitsubishi distributor used on various forklifts with the Nissan H-20 engine. These distributors typically have "22100" in the model number. Contact us if you have application questions.

FOR SALE IS A BRAND NEW CNH LINEAR ACTUATING CYLINDER CAP. THIS MILITARY SURPLUS PART WAS DESIGNED FOR USE ON THE M6F FORKLIFTS. THE PART NUMBER IS 1542986C1 AND THE NSN IS 3930011712135.

4,000# Prime Mover Articulating Four Wheel drive 4x4 forklift, Model# LL-40 Serial# 463 powered by John Deere 3 cylinder diesel engine, foot controlled hydrostatic automatic transmission with High/low range, 3 stage full freelift mast 90" lowered height with 15' of lift, Low 3,927 Hours, weighs 10,230 lbs.

enerpac hand pump with hollow ram setup for use with pullers, etc. works great.12 ton 1.63 stroke, 4.75" collapsed. Kit was $1600+016-10-01-121-901 PLEASE READ BEFORE BIDDING: Look at ALL the photos, not just the first one!

GENERAL ELECTRIC COIL VA747 22D135 G102 115 V, 60 HZ, 95 V QUANTITY: 1 NEW ;OLD STOCK INVENTORY #1922