hammer's end for sale, brand-new and used.

A stonemason or brick hammer that is not marked. It weighs 1 pound 8 ounces, total length is 11 1/4 " and it measures 7" from hammer face to chisel point. It has some dings, scratches and a small hole 1/4" deep in the end of the handle; handle is tight.

ebay template Matco Indestructible Handle Sledge Hammer

Stores Visit My eBay Store: liefdego &n

Wera 8002 C Koloss 1/2 inch Square Drive Ratchet with Hammer.

Up for auction is 1 piece SNAP-ON DX-160 hammer wrench 1-7/8 inch 12 point straight. I have owned this wrench since 1977 and did not use it often. I did clean and paint to sell,as it spent years in my service truck and in tool boxes.

Uses .22 caliber low velocity power loads to fasten up to 2-1/2" powder fasteners The strike of a hammer will actuate and fire a pin into concrete, steel or masonry. Ideal for mounting framing lumber, electrical junction boxes, conduit clips, & more Good Working condition.

Red Hook, Long Hammer IPA Beer Tap Handle, in good condition. Paint chip/nick on the top of the handle on the back side that is not visible when the tap is in use. See pictures *7 inch tall pub style beer tap handle.

Hello And Welcome.....this listing is for 6 brand new 16 ounce hickory forged claw hammers with a genuine hickory handle...they look just like the ones pictured. All domestic and international buyers please calculate for a shipping price for a 9 lb. package with each hammer being about 1 and a half lbs.

Welcome to the Auction! You are bidding on this Milw

Offered for auction is a vintage veterinary neurological reflex hammer. It is 7" long x 2.25" and the hammer ends are hard black rubber. The end of the handle screws off to reveal a small natural bristle brush.

Up for auction is this new Stilletto 14 oz framing hammer with a curved fiberglass handle. It has some scuffs from being stored, but has never been used. Thanks for looking.

CUTLER-HAMMER / EATON 3-POLE CONTACT KIT 6-43-4 SIZE L MN: CE15LN3 SERIES A1 & AUXILLARY CONTACTS PN: 1-C320KGS32, 1-C320KGS31 & 1- C320KGS21 Has general signs of normal wear and tear which may include scratches, scuffs, dirt, sticker residue etc on the exterior casing. PLEASE REFER TO PICTURES. Unit does not come with accessories unless noted in descr

For your consideration I have this used Milwaukee brand 1/2", 18 volt hammer drill driver model #0824-20. Included is the side handle and instruction manual. There are no batteries or charger included.

Fresh from a decommissioned building we offer this Cutler Hammer RD65k 2000 amp circuit breaker. Breaker was in use at the time of power disconnect. Breaker was tested at that time and functioned properly.

Vintage Smiths or Jewellers Bulb Handled Hammer Old Tool Click Images to Enlarge