Hollow Copper Rivets For Pcb Gnd On M/w Boards 200 Pcs

US $136

  • Morehead, Kentucky, United States
  • Jun 14th
Here are 200 pcs of soft hollow copper rivets that are perfect for providing ground vias through PC boards. Simply drill a hole, pop this through and use a center punch to spread the far side, then sodler both sides.  I have watched the various internet groups talk about how to do this, and finally remembered I had a few thousand of these! They are roughly 1/8 inch dia by 3/16 long  Note: I have measured the ID and found that a #47 drill (.078 in.) will easily pass through while a #46 (.081 in) is stopped by the internal lip at the smooth end (opposite the flare). If riveted with the appropriate swage, the ID should accomodate .080.  OAL is .125 inch, body diameter is .095, head diameter is .132 nominal, and the head thickness is negligable as it is a flare on the copper tube, difficult to measure so small. I weighed two hundred pieces then added a few so you get over 200!  I have learned that PCB repair houses sell rivets like this at 25 pcs for 20.00, this is a real bargain at 200 pcs for 15.00!!!  Have fun, see my other stuff if you are looking for microwave parts! Remember, I gladly will combine shipping to save you money! 

Directions

Similar products from Analog Semiconductors, Amplifiers & Modules

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies