Improved 200x300mm Dual Purpose 12v Or 24v Heatbed Pcb, 3d Printing Reprap Usa

US $37

  • Northfield, Ohio, United States
  • Jun 14th
This is a new improved heatbed design for 3D printers with 200x300mm print area.   The back side of the board has been extended in order to make it easier and more reliable to connect to.  Slots at the rear of the board are meant to zip-ties to secure power wires (see example photo of assembled unit).  The bed can be used with either 12V or 24V power supplies by selectively jumpering the points labeled on the board.  In 12V systems, the board will draw approximately 9A (110W), which makes it suitable for use with most reprap control boards.  There is a mounting hole for a traditional thermistor to be taped to the back side of the board, as well as pads for a 0402 SMT thermistor if you wish.   Specifications: Print area (mm): 200x300 Resistance: 1.2 - 1.4 Ohms (12V mode) or 2.4 - 2.8 Ohms (24V mode) Package includes: 1. Heatbed PCB (unassembled) 2. Red LED 3. 1K resistor On Feb-26-16 at 10:03:41 PST, seller added the following information:

Directions

Similar products from Analog Semiconductors, Amplifiers & Modules

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies