Hose Clamp Pliers by Vise Grip. Jaws designed to easily install or remove wire spring tension clamps. Features: dipped rubber grips, machined jaws for maximum strength,wire shearing feature and lifetime gaurantee.
K Tool New 12" Long Cast Iron Pipe Wrench with Drop Forged Steel Jaws Features and Benefits: Strong, durable and versatile Cast iron with drop forged steel jaws KTI wrench is constructed from the highest grade cast iron, forged and heat treated to ensure maximum durability Tough red enamel finish Tool is strong and versatile. 2-3/8" capacity. Lifetime warranty Check out our Ebay Store for other great products!
K Tool International New 2 5/8" Capacity 14" Long Aluminum Pipe Wrench with Steel Jaws Features and Benefits: Weighs 40% less than its cast iron counterpart Easier to handle and causes less hand fatigue and arm stress Features strong hardened jaws, nuts and teeth, and drop forged steel jaws A versatile head design provides a flat surface for hammering Lifetime warranty Check out our Ebay Store for other great products!
This sale is for ONE GROUP of THREE NOS ( new old stock ) USA MADE Ridgid HOOK JAWS. These jaws are manufactured from alloy steel and the 12" jaw has been oil hardened for extra strength. Included in this sale are one each of: 12: jaw (6" OAL), 10" jaw (5" OAL) and 8" jaw (4" OAL) They are designed for Ridgid pipe wrenches.
This auction is for a used but not abused RIDGID Pipe ViseModel No.38 - 1/8" to 2" pipe capacity.This clamp-on bench model is in excellent working condition, the jaws show no wear. Jaws are True - Screw is Smooth16" Long w/ both pipe & bench clamps closed. Will make a nice addition to your gang box for job sight useage.
Clausing L00 mount chuck, 8" 3 jaw. Both inner and outer jaws are included, in very good to excellent condition. Jaws move smoothly throughout their range.
Up for Sale is 1-New PSI Woodworking CJAWFJ2 Jumbo Flat Jaws for Lathe Chuck " 2in to 8in Diameter ". This is an open box item with 4 pie shaped steel plates and 16 rubber pin stops. 8" flat jaws used for finishing bowl bottoms when attached to a Barracuda scroll chuck.
10" Diameter Lathe Chuck with a 4" Through Hole. We removed the jaws and cleaned out the scroll and replaced them and they turn in and out fairly smoothly. There is a slight drag at the same point on the scroll.
This is a Wilton Brink and Cotton Vise with suction base that holds to a smooth surface. The jaws are about 2 3/4 ” wide and open about 2 1/2 ”. Total height of the vise is about 7 3/4 ” and the base is about 5 1/8” at the widest point and 3 3/4 ” at the narrowest point.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.