Jdsu Validator Pro Nt1155 With Nt1025 Remote

US $650

Orlando, Florida, United States
Jun 10th

Open on mobile:
QR code

Gently used JDSU NT1155 cable tester kit. Contains: 1x NT1155 1x NT1025 8x remote plugs 1x USB cable 1x Power/recharge cable 1x JDSU carrying case Various small shielded cat5 cables Various alligator clip cables Validation sticker sheet Everything works great and is tested. The JDSU ValidatorPro-NT NT1155 builds on the capabilities of the JDSU Validator-NT, the JDSU ValidatorPro series of Ethernet Network Management Tools offers a complete solution to test copper and fiber Ethernet network cables. The ValidatorPro-NT Ethernet Speed certifier with integrated optical power meter and accompanying Plan-Um cable management software delivers the power to test both copper and fiber cabling, determine if cables can support Gigabit Ethernet, and perform troubleshooting for cable installations. The ValidatorPro-NT performs all tests offered by the Validator-NT, including speed certifying the data-carrying capabilities of copper Ethernet network cables up to 1 Gb/s by testing for noise in the network, detecting faults in the cabling wiring, and ensuring that cables can support the speed capabilities of active equipment. To certify Ethernet speed performance of cable runs the ValidatorPro-NT conducts bit error rate (BER) tests by sending data packets down specified cable runs a defined data rates to check for errors at the maximum throughput of the link. The ValidatorPro-NT also reports on signal quality that can impact high-speed data transmission by measuring signal-to-noise ratio (SNR). Skew measurements provide the signal time delay between pairs that can impact Ethernet data transmission. The ValidatorPro-NT also provides continuity testing that detects opens, shorts, miswires, split pairs, reversals, and high-resistive faults while measuring distance to faults and total cable length. The ValidatorPro-NT includes an intergrated optical power meter that measures optical power at 850/1300/1310/1490/1550nm on multimode or singlmode fiber to address an increasing number of Ethernet networks that now include optical links. The ValidatorPro-NT version includes a comprehensive set of features for testing a networks active network capabilities: measure Power over Ethernet (PoE) to ensure correct power is available on the correct pins, use port discovery to ensure the correct speed and duplex capability available; connect at Gigabit Ethernet and run Ping tests to verify connectivity to IP hosts; discover network devices using Cisco Discovery Protocol (CDP) or Link Layer Discovery Protocol (LLDP), discovery and display essential information regarding functionality and configuration of 802.11 b/g/n wireless networks.