laird notebook CPU solid grease , thermal pad , thermal silica films paste graph, US $7.38 – Picture 0

laird notebook CPU solid grease , thermal pad , thermal silica films paste graph, US $7.38 – Picture 1

Laird Notebook Cpu Solid Grease , Thermal Pad , Thermal Silica Films Paste Graph

US $7.38

Shenzhen, Guangdong, China
Mar 12th

Open on mobile:
QR code

Specifications: Length 1.5cm x Width 1.5cm x thickness 0.12mm ( roughly equivalent to the thickness of ordinary printing paper 70 g ) ( Note : I3/I5/I7/AMD notebook CPU requires the use of two tile , or phase-change shop another extended version ) Thermal conductivity : 4.5W/mk Weight:0.15g/pcs Scope: Principle : replace thermal paste applied to the chip and heat sink can be directly exposed to the thermal interface . Example : More than 99% of the small area of the notebook CPU, a small part of the notebook graphics GPU, a small part of the notebook graphics Northbridge , part of the desktop graphics card GPU, Northbridge , etc. Use Description: 1 , remove the heat sink and fan of dust, remove the old chip and heat sink thermal product contact surfaces 2 , between the chip and heat sink can determine the direct exposure to 3 , determine the position of the chip on the heat sink in contact with the heat sink 4 , the phase change on the release side of the release paper better separation 5, the phase change posted in the third step to determine a good position ( toward the bottom of the heat sink attached to the chip surface than to stick to Haotie lot ) 6, the phase change more than wiping pressure several times, especially in the edge part , to make snapping the radiator surface 7 , after waiting for about two minutes or so, from one side of the phase change carefully peel the release paper on the other side , that is OK. Caution: 1 , do not use the chip and heat sink can not come into contact with the interface , the interface can not touch with a soft thermal film or composite thermal film . 2, do not use two superimposed 3 , the radiator to tighten the screws to ensure a certain degree of pressure on the phase change , the weight of the thinner the better. 4 After installation please CPU running at full capacity for about 30 minutes ( ensure that the CPU is running at 50-70 degrees to ) , then the material under heat and pressure of the situation first phase transition occurs , any slight gap filling and then re- forming, will show the total thermal resistance is further reduced , the best results require a longer period of time the machine is running , after five or six times more than the run . 5 , the phase change will occur after the use of phase change material type , so the open again , generally need to be replaced .

Condition:	New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...	Brand	3M
Country of Manufacture	Unknown