lathe hard jaws for sale, brand-new and used.

12" Ajax Lathe Chuck Jaw Tools 3 Double Step Hard Jaws 12" Critical Chuck Dimensions: * Length 5.024 * Height 2.75" * Width 2.00" * K /Slot .827" * Screw Size 16mm * Center Distance Between Screw Holes 1.181"

12" Ajax Lathe Chuck Jaw Tools 3 Single Step Hard Jaws 12" Critical Chuck Dimensions: * Length 4.45 * Height 2.05" * Width 1.970" * K /Slot .709" * Screw Size 14mm * Center Distance Between Screw Holes 1.181" 3 NEW AJAX 12" HARD STEEL LAT

3 Brand new Hard Lathe Chuck Jaws up to 15" chuck capacity. Steel 2" high. The jaws are 3 5/16" long and 7/8" wide.

Very lightly used hard jaws with fine serrations on bottom and nice sharp gripping surfaces for 10" chuck.

Bison - 4 Jaws, 12 Inch Diameter, Independent Manual Lathe Chuck L-2 Mount Spindle, Reversible, 3.1496 Inch Through Hole Diameter, Cast Iron, Includes Set of Clampi

6 American Tongue & Groove Standard Hard Jaws *GROUND SET OF 6 PCS* Made to Fit American Standard Master - Bergman, Buck, Cushman, Pratt Burnerd, Bison, Rohm, SCA, S-P, Warner & Swasey and Yuasa Chucks. 6" Critical Dimensi

var itemNumber = window.ebayItemID ?

var itemNumber = window.ebayItemID ?

var itemNumber = window.ebayItemID ?

var itemNumber = window.ebayItemID ?

var itemNumber = window.ebayItemID ?

var itemNumber = window.ebayItemID ?

var itemNumber = window.ebayItemID ?

var itemNumber = window.ebayItemID ?

var itemNumber = window.ebayItemID ?

var itemNumber = window.ebayItemID ?

This is a Bison 3 Jaw chuck, 6.25" actual diameter. Through hole is 1.65", so you can get a 1 5/8" rod through the headstock. This is a quality chuck rated at 4500 RPM, which is double the speed rating of most cheaper chucks.

1 Pc. Bison-Toolmex Brand New 12" 4-Jaw Semi Steel Body Independent Lathe Chuck, w/Solid Jaws. This Chuck is plain back that would need to be mounted on a backplate and then onto a lathe.

1 Pc. Bison-Toolmex Brand New 12" "SET-TRU" Scroll 3-Jaw Forged Steel Body Lathe Chuck, 0.0004" TIR, w/Two-Piece Reversible Hard Jaws, Fine Adjustment, 3 Pinion Design. This Chuck is rear mounting, plain back chuck that would need to be mounted on a backplate and then onto a lathe.