JOHNSON CONTROLS METASYS FM-ORE101-0 FUNCTION MODULE ASSEMBLY OUTPUT RELAY ELECTRICALLY MAINTAINED Note: These ARE FACTORY SEALED and are ready to install in your system! Check My Feedback and Buy With Confidence! Posted with eBay Mobile
JOHNSON CONTROLS FM-OAI101-0 FUNCTION MODULE Assembly Analog Output Isolated New, open box Comes only as pictured in original box/packaging Washington state residents must pay Washington state sales tax
Reznor TE-6001-1 Duct sensor module assembly for TE-6000 Temperature Elements. Buy with confidence! My commitment is to provide exceptional customer service, and I strive for 100% positive feedback.
Description for Honeywell 394800-30 30" Ignition Cable Assembly with a right angle boot for ignition terminal and 1/4" straight quick connect at module end for S8600 family.
The Amron International Amcommand II Two Diver - Air Control/Communications System is a portable, self contained, two diver complete commercial dive system. This air control system provides all of the operations necessary to monitor and control the commercial diving operation. It is a central control point for the supply of breathing air to the commercial divers.
Type: PA11 Module: DN10-15 Ball Valve Type: 546 DN15 Type PA11 Pneumatic Actuators Our Pneumatic Full Plastic Actuators PA11 can serve you in many ways. Accessory assembly to our PA11 is easy due to the new position indicator with integrated NAMUR interface. The flange interface also corresponds naturally to the NAMUR standard; therefore, third party valves are no problem.
Integral photocell: Unit operates as a dusk to dawn luminaire and in the event of a power failure as an emergency light. Remote Switched: The integral photocell can be defeated to allow remote switching for normal operation. In the event of a power failure unit operates as an emergency light.
This is a butterfly laser diode housing with a tested good TEC. The unit would be good for making a custom laser testing jig or cooler for a special project. It is pretty hard to find.
This is a collimator lens for an older laser module that had a 200mw 635nm laser diode in it. The lens is mounted in a small holder as shown with a 5/16 output diameter lens. The lens has a relatively longer focal length of 3/4 inch allowing it to work with the higher power type 635nm laser diodes.
This is a complete kit needed to assemble a 445nm laser module except for the diode. You get the following: 1 - AixiZ module case including ring, acrylic lens, spring, diode mount and end case 1 - 405-455nm 1W compatible driver board 1 - AR coated specialty AixiZ lens for 405-455nm laser diodes Buy now and have fun!
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.