This is a Vintage Strong running 1/4 Horsepower General Electric motor from a Wood Lathe. Comes as pictured with an on/off switch mounting bracket and clips and Bolts as pictured. Has a 1/2" diameter shaft flat sided about 1 3/4" long 1/4 Horsepower 115 Volt 60 Hz 1725 RPM 5.6 amp single phase Reversible Currently wired clockwise (Right handed at shaft end).
Dumroe Series 5 Grinder Motor Saddle, mounted on a bracket that would allow bench mounting of the motor. The motor saddle is an original Dumore part. No idea what the bench mount bracket is from.
This listing is for the most advanced motor connectors offered to date for the Gecko G540 stepper controller along with 3 10ft shielded (ZERO ASSEMBLY REQUIRED) DB9 motor cables THESE CABLES ARE INSULATED PROPERLY FEATURING 300V CAPACITY, AND 80C TEMPERATURE RATING (Review the picture of the cable). . These connectors can be typically used on any controller that utilizes a DB9 female port or modified for other controllers.
Melles Griot Nanostep 1000 Stage - 17NST104 - 150 mm Travel Linear Stage in excellent working condition. Each stage unit comes with a full set of Melles Griot Table Mounting Bracket (End & Side) and a Melles Griot Instruction Handbook. The stage can be connected to the Nanostep controller via a flying lead terminated in a LEMO 8-pins type connector.
THIS IS A MINARIK DC GEAR MOTOR THAT HAS A MARTAIN GEAR AND A METAL BRACKET. THE MINARIK GEAR MOTOR'S PART NUMBER IS 507-01-132A AND THE ACTUAL GEAR IS A S24 144 14 1/2. THIS GEAR MOTOR HAS THE FOLLOWING LISTED: HP: 1/20 AMPS: .58 VOLTS: 90 VDC RPM: 25 RATIO: 71.7:1 TORQUE: 100 IN-LBS THIS MOTOR HAS NOT BEEN TESTED AND WAS PARTS REMOVED FROM A SERVICE ROOM THAT WAS IN WORKING CONDITION.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.
