Oxalic Acid, 2 Lbs. Rust Remover, Bleach Teak Decks, Clean Gems, Rocks, Leather

US $2000

San Pedro, California, United States
May 29th

Open on mobile:
QR code

OXALIC ACID, 2 lbs. RUST REMOVER, BLEACH TEAK DECKS, CLEAN GEMS, ROCKS, LEATHER THE ITEM YOU ARE BIDDING ON IS 2 LBS OF OXALIC ACID. USED FOR BLEACHING TEAK OR HARDWOOD DECKS, RUST STAIN AND FISH BLOOD STAIN REMOVER FROM FIBERGLASS. ALSO WORKS GREAT TO EAT RUST OFF ANY METAL SURFACE. GREAT FOR RESTORING CAR PARTS OR OTHER MACHINERY. EVEN CLEANS HEAVY OXIDATION OF VARIOUS GEMS FOR THE ROCK/GEM INDUSTRY.THIS IS PURE OXALIC AND IS VARY STRONG. DILUTE IN SOLUTION OF WATER AND APPLY TO AREA. DIRECTIONS INCLUDED. SMALL AMOUNT GOES A LONG WAY! to save you shipping I will put in a heavy duty ziplock bag with label and ship priority mail. (alot less than UPS) USES OF OXALIC ACID 1. BLEACHING TEAK DECKS (OR EVEN YOUR PINE DECK AT HOME) DISSOLVE 1/3-1/2 CUP OF CRYSTALS IN A GALLON OF WATER. APPLY WITH BRISTLE BRUSH, SCRUB LIGHTLY. LET SOAK INTO WOOD UNTIL DESIRED TONE IS ACHIEVED (10 - 15 MINUTES?) RINSE THOROUGHLY TO NEUTRALIZE ACID. MAY ALSO BROADCAST CRYSTALS OVER WET SURFACE, SCRUB LIGHTLY AND RINSE WELL. WOOD CAN LOOK NEW AGAIN! 2. REMOVING RUST FROM METAL SURFACES. DISSOLVE 2-3 TAABLESPOONS WITH A GALLON OF WATER (EXPERIMENT QUANTITY DEPENDING ON EXTENT OF RUST) BEST TO SOAK METAL OBJECT IN SOLUTION FOR UP TO AN HOUR. IF UNABLE TO SOAK, CONSTANTLY BRUSH ON, RETAINING WET SURFACE TO GAIN DESIRED EFFECT....A ZINC PHOSPHATE COATING IS LEFT ON SURFACE WHRN DRY. PRIME RIGHT OVER THIS SURFACE...IT ONLY EATS RUST, AND WILL NOT HARM PAINT, CHROME, OR GLASS. I HAVE HAD NUMEROUS TESTIMONIALS TELLING OF REMOVING RUST FROM OLD BEER CANS TO BOTTLECAPS IN AS LITTLE AS 15 MINUTES!. GREAT FOR REMOVING RUST FROM MOTORCYCLE FUEL TANKS AS WELL. 3. REMOVES RUST AND OXIDES FROM ROCKS, GEMS & CRYSTALS. FOLLOW SAME INSTRUCTIONS AS REMOVNG RUST FROM METAL SURFACES. ALSO GREAT FOR REMOVING RUST STAINS FROM BATHTUBS AND TOILET TANKS. 4. REMOVES IRON OXIDE (BLACK STAINS) FROM LEATHER. WHEN VEG-TAN LEATHER COMES IN CONTACT WITH ANYTHING METAL, IT LEAVES A BLACK IRON STAIN. SO BEFORE THE LEATHER CAN BE DYED & FINISHED WITH A SEALER, IT HAS TO BE CLEANED OF THAT IRON OXIDE THAT IS ABSORBED BY THE LEATHER. ALWAYS WEAR RUBBER/LATEX GLOVES AS IT WILL FIND ANY SCRATCH OR OPEN CUTS ON YOUR HANDS....FRESH WATER QUICKLY EASES ANY DISCOMFORT. KEEP OUT OF REACH OF CHILDREN IF BY CHANCE BIDDING, BIDDING GOES UP A FEW DOLLARS, I WILL SEND YOU 3 LBS FOR YOUR 2 LB BID! On Oct-27-14 at 04:35:54 PDT, seller added the following information: