Plasmabob For Plasma, Laser Cnc Routers (breakout Board Bob)

US $154.00

  • Ufa, BA, Russian Federation
  • Feb 21st
First breakout board (BOB) designed specially for CNC plasma and laser routers. Maximal protection against EM interference. - fully galvanicaly isolated LPT port - high-speed optopairs on motors - fully galvanicaly isolated DC power 12-24 V - strictly isolated relay - tuned sensor inputs to avoid any EM interference STEP, DIR, ENABLE for stepper motors drivers STEP, DIR, S-ON (12 V) for servo motors drivers Three cards connected by patch cords. Place one card near PC, and two sensors cards at any location at the router. Sensor cards provide power for sensors, both supports PNP and NPN sensors.
Condition:
New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. ...
Brand po-mo
Country/Region of Manufacture Russian Federation
Model PlasmaBOB
UPC 749354994947

Directions

Similar products from Stepper Motor Driver Boards & Modules

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies