point relay for sale, brand-new and used.

Attention: you need a 7.5 hp 17xx rpm three phase motor (idler motor) to use in conjunction with this panel to create three phase power. I purchased this great phase-craft control panel to use with a 7.5 hp three phase motor in order to run my 5 hp table saw. The builder is top notch and this unit is professionally overbuilt.

Subscribe to Our Newsletter

CrazyLister

Click Here. Double your traffic. Get Vendio Gallery - Now FREE!

BTU C-RHGE-15-3 @480V - Electric Heat Strip - 15 KW, 3 Phase, 480 Volt Item No.: RHGE153480V BTU - Electric Heater for RHGE Series Rheem units. ARL Listed Close Coupled Duct Heater L/N 29707 Zero Clearance - Primary and Secondary Protection Built in Fan Interlocking Relay Hinged and Latched Cover Single Point Line Connection, Fuse Block and Fuses for Blower Motor, Three-Pole Contactor for Blower Motor, Flex Cable, Fittings and Wires.

BTU C-RHGA-20-1 @240V - Electric Heat Strip - 20 KW, 1 Phase, 240 Volt Item No.: RHGA201240V BTU - Electric Heater for RHGA Series Rheem units. ARL Listed Close Coupled Duct Heater L/N 29707 Zero Clearance - Primary & Secondary Protection Built in Fan Interlocking Relay Hinged and Latched Cover Single Point Line Connection available upon request Air Pressure Switch available upon request Plenum Section 20" x 20"

BTU C-RHGA-10-3 @208V - Electric Heat Strip - 10 KW, 3 Phase, 208 Volt Item No.: RHGA103208V BTU - Electric Heater for RHGA Series Rheem units. ARL Listed Close Coupled Duct Heater L/N 29707 Zero Clearance - Primary & Secondary Protection Built in Fan Interlocking Relay Hinged and Latched Cover Single Point Line Connection available upon request Air Pressure Switch available upon request Plenum Section 20" x 20"

NOTIFIER by Honeywell UDACT Universal Digital Alarm Communicator Transmitter VERY GOOD CONDITION Item that has been used previously Clean and intact but may have some signs of cosmetic wear I cannot test item but it comes with a full refund no Defective on arrival (DOA)

.art-content .art-postcontent-0 .layout-item-0 { margin-top: 0px;margin-right: 0px;margin-left: 0px; }.art-content .art-postcontent-0 .layout-item-1 { border-top-style:solid;border-right-style:solid;border-bottom-styl

LNL-1100 Overview The Lenel® Input Control Module (ICM) provides the access control system with high-speed acknowledgment of critical alarm points in monitored areas. The ICM communicates directly with the Intelligent System Controller (ISC) either by 2-wire or 4-wire RS-485 communication. The ICM has 16 configurable input control points and 2 output control relays.

Omega temperature control is used but almost like new. Multi use such as RTD 2,3 and 4 wire or thermocouple J,T, N,K,...... But meter set for K type and temperature F.