Up for sale is a used Moving Cool Spot Cooler, model 20HFU-1. 208/230 volt, single phase, 60 hz, 1.5 kw compressor output, uses r-22 refrigerant, 22000 btu/hr cooling capacity. It is missing the cover on the back and the knob for the thermostat adjustment - thermostat can be adjusted by hand though.
Basically brand new-installed and used for two weeks before the air handler furnace unit went out so I replaced everything with a 5 ton r410 system. Burn mark on label was from the torch when it was installed and not from a compressor problem
This unit was gently used in a coffee shop that operated 4 months out of each year. It was purchased used from an individual who used it for personal parties. 2 years ago, we replaced All Auger Boots, Flights, Springs, O-Rings and Mix Inlet Regulators.
THERMAL CARE ACCUCHILLER WATER CHILLER MODEL: AQ0W0504 VOLTAGE: 460V 3PH 60HZ FULL LOAD AMPS: 14 COMPRESSOR: 1 QTY 5 HP PROCESS PUMP: 1 QTY 1.5 HP REFRIGERANT: R-22 16 LBS MINIMUM TEMP: 30 °F MAXIMUM TEMP: 60 °F HEAT TRANSFER FLUID: 30% GLYCOL 5 TON
One (1) used 16 ton Carrier chiller, model 30GT020-6, 16.6 nominal tonage, 19.4 kw compressor, r-22 refrigerant, 460 volt, built 1995. This quality used equipment is offered by:The Proxio Group Ltd514-262-7727C
Kaeser Compressed Air Dryer HTRD 20 Dryer for compressor 20 SCFM 20 SCFM @ 125 PSIG & 180° 34 m3/h @ 8.6 BAR & 82°C Maximum Working Pressure 175PSIG Maximum Inlet Temperature 180°F Unit
Copeland A/c compressor 2 and 1/2 tons, R-22 , 230v 1 Phase. Came out of a working unit. What you see is what you get but I will need to remove some excess piping to seal and crate compressor for shipping.
Copeland a/c compressor. Came out of a working 3 and 1/2 ton rooftop A/C unit that was being replaced. What you see is what you get, I will need to remove most of the piping so I can seal and crate for shipping.
2 and 1/2 ton a/c compressor R-22, 230v, 1phase, Came out of a working but very dirty and rusty ac unit located by the beach and salty air. but works fine. What you see is what you get, but I will need to remove most of the excess piping and seal for crating and shipping.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.