Radiant Heat System For Use With Waste Oil Boilers- Single Zone

US $3,149.00

Olathe, Kansas, United States
Jan 29th

Open on mobile:
QR code

Hydronic Heat Control Panel- Single Zone/One Temperature Includes 3 Way Mixing Valve for Use With Alternative Fuel Boilers TAKE the Mystery out of the Mechanical Room Our Hydronic Radiant Heat Control Panels can be used with: In Floor Heating (PEX tubing in concrete slab) Thin Slab Concrete Radiant Heating (thin concrete layer on top of wooden floors) Under Floor Heating (PEX tubing with or without heat transfer plates) Baseboard Heating (hot water heating)Our radiant heat panels are the perfect solution for any project: floor warming, heating, or snowmelt. Pre-piped, pre-wired, and shop tested by trained professionals. These panels will dramatically reduce installation time as well as virtually eliminate wiring and other start-up problems. The only wiring required is to connect the zone thermostats to the corresponding relay terminals. Each mechanical package is pre-wired with a 120 volt power cord. Connecting one panel to another is as easy as turning the hex nut on the brass o-ring seal union. Best of all, each of our hydronic panels are designed for easy system maintenance. Each component on the panel can be easily accessed and isolated with numerous shut-off valves located on all panels. So, don’t let your next radiant project slow you down. Our hydronic panels are fast, easy, and guaranteed to take the mystery out of the mechanical room. This Radiant Panel’s Specifications; Boiler: The boiler is not included in this listing. The panel can/will be custom built to plumb to the boiler you intend to use. Electronic Zone Controller: TACO 1 zone controller with installed power cord for plug in installation to your existing 120 VAC outlet. A service on/off switch is provided. One air sensing thermostat is supplied and the controller is wired to service this thermostat. No on-site high voltage electrical wiring is necessary. Circulation Pumps: Two TACO circulation pumps installed with service shut-off valves on both sides. Microbubble Air Remover: TACO Zone Ports: Each zone port(s) is equipped with either 3/4” SharkBite or PEX crimp fittings for a quick no solder connection. Zone port(s) are equipped with shut-off valves. Ports will be installed in whatever configuration makes your installation easier for you, i.e. up or down or any configuration of these. Other Features: Auto Fill Port with Backflow Preventer, Custom Sized Expansion Tank Included, Pressure reducing valve, Temperature/ Pressure Gauge on Boiler Out Side, Manual Glycol Fill Ports, System Drain Valve for Connection to Water Hose. The biggest cost of any Hot Water Radiant Heat System is the labor to build and install. Due to the special requirements of Radiant Heating Systems local plumbers and heating companies are often not familiar with the specifics of system builds. We take the guesswork out of system build utilizing our skilled Engineers and system builders. You know what your costs are going to be upfront. We custom design each and every radiant heat boiler panel system to your specific system requirements. If this particular unit does not meet your needs we can custom build a panel specifically to your requirements. Let us help you TAKE THE MYSTERY OUT OF THE MECHANICAL ROOM.