this is a new , unused pump that I picked up at an auction. It has a little surface rust just from sitting in my garage. I have two of these pumps available.
ELECTRIC MOTOR SET FROM CIRCULAR COLD SAW ACCURA 12" 2 1/2 HP single phase with control panel New take off motor Sold saw to an Amish Shop and they did not use electric. 220 Volt Single Phase 1720 RPM 16 Amp Comes as shown.
GE 5 HP FARM DUTY MOTOR 220 VOLT SINGLE PHASE This is a MONSTER GE 5 HP Motor. Farm Duty. 220 volt single phase 215 TZ 1740 RPM USA made in Nashville Motor Plant with pulley 9" 2 groove cast iron
This is our new line of LARGE FRAME low cost - better than the competition - magnetic starters. These are available in this configuration up to 50 HP @ 480V; 30 HP @ 208/230V 3-phase; 15 HP @ 230V 1-phase. Our motor starters use UL certified IEC type components.
This is our new line of LARGE FRAME low cost - better than the competition - magnetic starters. These are available in this configuration up to 50 HP @ 480V; 30 HP @ 208/230V 3-phase; 15 HP @ 230V 1-phase. Our motor starters use UL certified IEC type components.
This is our new line of LARGE FRAME low cost - better than the competition - magnetic starters. These are available in this configuration up to 50 HP @ 480V; 30 HP @ 208/230V 3-phase; 15 HP @ 230V 1-phase. Our motor starters use UL certified IEC type components.
This is a strong running Heavy electric motor from a Vintage Shopsmith 10-E Dust and dirt wear and tear rust and pitting but in good working condition. 1/2 Horsepower single phase 1725 RPM 120 Volt 7 amp 60 cycle. Has a 5/8" diameter shaft with key slot about 2" long overall.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.