Sp45 Primer For Uv Printing (for Plastic - Organic Glass). 100 Ml Pack

US $2700

  • Vilnius, Lithuania
  • May 25th
PRIMER FOR UV-PRINTING ON ORGANIC GLASS (POLYMETHYL METHACRYLATE)  APPLICATION INSTRUCTION  • The surface of the organic (acrylate) glass must be clean and dry. • Quickly apply a thin layer of the primer on the surface of the item, wiping it with napkins, dustless fabric sprinkled with the primer. During application, place the glass at a shallower angle for avoiding appearance of primer’s thick layer. Do not use primer twice for one place – it can lead to formation of white irremovable spots.  • Dry the item during 5-10 minutes at room temperature. Do not use air heating for item drying – it can also lead to whitening of the surface. • Print.   PRIMER CONSUMPTION   Primer consumption is 100 ml on 3.5-4.5 sq. m.   SAFETY PRECAUTIONS  The primer contains toxic volatile and flammable components, therefore you should observe following safety precautions during its application: • Use it in well ventilated areas. • Do not carry out work near the open fire and strong source of heat. • Protect your hands with the rubber gloves. • In case of a contact with skin and clothing, the primer should be washed off by a jet of water.   STORAGE   • The primer should be stored in a dark and cool place at the temperature no higher than 300C with tightly closed lid. • Cold-resistant.   NOTE • Note that the primer is not intended for increasing of mechanical resistance, firmness, abrasion resistance of a cured printed layer. These properties are determined by a brand of the used inks.

Directions

Similar products from Large Scale Printers

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies