Coni-Seal Drum Brake Wheel Cylinder - WC13904 ITEM : Military Spec. Round Channel Spring Nut - Thread M14-1.5 - Made in USA The photographs shown are of the actual item. Brand: Unknown Quantity: 6 Model: Round Channel Spring Nut - Thread M14-1.5 Description: Aircraft Surplus Round Channel Spring Nut - Thread M14X1.5 - Materials Unknown, all three materials are not magnetic.
This is a very gently pre-owned and very lightly used, if at all, rare and unique vintage revolver holster from COLT. This is a marked genuine COLT article. This holster is rendered in BLACK rubber and features a minimalist design that retains the pistol with the least possible coverage.
Up for bid is a NEW, never used 10 ton Hytec OTC 100270 ram (similar to an OTC - C102C ram selling for $350 from a dealer). They are ideal for any heavy duty applications found in construction, mining and other industries where high cycle rates are required.
Up for bid is a NOS, never used 10 ton Hytec OTC 100296 ram (similar to a new OTC ram selling for $350 from a dealer). They are ideal for any heavy duty applications found in construction, mining and other industries where high cycle rates are required.
OTC 300-Ton Non-Spring - Return Solid Center Hydraulic Ram. Features and Benefits OTC 300-Ton Solid Center Hydraulic Ram ideal for push/pull applications f
Power Team 10 Ton Capacity. Low profile for limited-clearance lifting jobs. 1.75" Retracted Height, 2.19" Extended Height, 2-3/16" x 3-1/4" Outside Diameter.
This is for 3 new tools 3 broken spring /key removers,or other Miscellaneous Uses. These are dental tools but work fine in the locksmith trade, they will get inside a lock cylinder and reach into a pin hole to remove a jammed/stuck or broken spring, a key or ????????? whatever else you need them for.
If you ever had a problem loading springs or pins into a cylinder housing because they keep tipping over, THEN THIS IS FOR YOU. It's a new type design of follower. Instead of the flat base notch that you are using now to put the spring and the pin against and then pushing down into the cylinder hole without tipping them over, you put them into the new "V" cut notch and it keeps them upright so they don't tip over when you push down into the hole.
If you have ever had a problem loading the springs and pins into a cylinder housing because they keep tipping over, THEN THIS IS FOR YOU. It's a new type design of follower. Instead of the flat base that you are used to using to put the spring and the pin against and then pushing them down into the cylinder hole without tipping them over, instead you put them into the "V" cut in the new follower and it keeps them upright so they don't tip over when you push them down into the hole.
Tricks & Secrets of Old-Time Machinists: Hints and Kinks Provided by the Readers of American Machinist Magazine in 1915 and 1916, Volume 2, originally published in American Machinist Magazine, compiled, edited and published by Lindsay Publications, 2008. 5 1/2 x 8 1/2 paperback, 96 pages. ISBN 1-55918-371-3.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.