stainless d ring for sale, brand-new and used.

Vitrectomy Lens Set (Autoclavable) (7 Lenses + 2 Ring)

Vitrectomy Lens Set (Autoclavable) (7 Lenses + 2 Ring)

Vitrectomy Lens Set (Autoclavable) (7 Lenses + 2 Ring)

About us Shipping Payment

Patented design pump head FEATURES: MANIFOLD: NEW high efficiency design concept. Patented forged brass for strength and no porposity for long life and higher hydrostatic pressures BOLTS: Eight 6mm grade 8.8 PLUNGERS: Ceramic coated stainless steel CRANKCASE: Precision die-cast cooling fins and anodized for maximum heat dissipation BEARINGS: Oversized for maximum life and load disbursement, needle bearing on the drive side and ball on the non drive side.

I have 3,150 D-Rings, 306 stainless steel, un-welded with a bent leg. These were mis-ordered and can not be returned....taking loss to move dead inventory. Asking only $100 for ALL (about 3 cents each).The D-rings are 1" inside across the flat edge and measure 3/4" inside top-to-bottom.The complete box weighs 38 lbs.

German made stainless 2mm E-Clip / Snap Ring / Circlip - Lot of 25 Great for RC Models or industrial applications Manufacturer: Bossard GmbH See drawing representing the end of a shaft machined for circlip. Fits 2.0mm diameter machined groove (dimension D). Groove width (dimension W) should be at least 0.64mm.

Lot of 20 German made stainless 3mm E-Clip / Snap Ring / Circlip Manufacturer: Bossard GmbH See drawing representing the end of a shaft machined for circlip. Fits 3.0mm diameter machined groove (dimension D). Groove width (dimension W) should be at least 0.64mm.

German made stainless 3mm E-Clip / Snap Ring / Circlip - Lot of 100 Manufacturer: Bossard GmbH See drawing representing the end of a shaft machined for circlip. Fits 3.0mm diameter machined groove (dimension D). Groove width (dimension W) should be at least 0.64mm.

German made stainless 4.0 mm E-Clip / Snap Ring / Circlip - lot of 10 Manufacturer: Bossard GmbH See drawing representing the end of a shaft machined for circlip. Fits 4.0mm diameter machined groove (dimension D). Groove width (dimension W) should be at least 0.64mm.