teel pump for sale, brand-new and used.

Electric Drive Polypropylene Chemical Solution Pump with Magnetic Drive. I believe this is a TEEL pump, but I cannot be sure. Was used for a short time in a fish aquarium.

For your consideration is this vintage and what appears to be rebuilt TEEL circulating pump. The Label has a Tag No. 1P761.

Teel Industrial dayton split Phase Jet Pump motor 9K679H.P. 1/2, RPM 3450, Volt.115,HZ 60Phase 1, KVA Code-P,S.F. 1.0BRGS/Ball/SLV

var itemNumber = window.ebayItemID ?

Used circulator pump off of residential hot water heat system. Been sitting around for 5 years since I got new boiler. Only used it 3 years.

You are bidding for Teel pump. This unit is like brand new Model 3P511P HP 1/3 PH 1 HZ 60 RPM 1725 Type SN Volts 115 Amps 6.0 Rise 55 degree C Thermally Protected Made in USA Dayton Electric Manufacturing Excellent condition

.shippingcalculator a { display:block; width: 208px; padding:177px 0px 10px 0p

Teel 1P985 3.5 hp gas polyester pump 8460 gph Used pump, tested, works fine. Local pickup only please.

New old stock TEEL Bronze Pedestal Gear Pump Model: 1V426 Pipe size: 3/4" Shaft diameter: 3/4" Rotation: CW/CCW Pump RPM: 900 to 1200 Motor HP: 3/4 at 25PSI 2 at 125HP Pedestal size: 4" x 1-1/2" Pump is excellent for water-based fluids. Spur gears provide quiet operation. Pump have 303 stainless steel shaft, ball bearings and carbon graphite bushings.

Stainless Steel Bullet Recovery Tank Made by Emark Fabrications in West Falls, NYUnit was removed from a facility that no longer used it or needed it. It was made for the facility at a cost of over $27,000. Unit does have a light on the inside of the tank.

, THINK THE PRICE IS TOO HIGH? MAKE ME AN OFFER !

This new Dayton carbonator pump motor has been sitting in my shop in an unopened box. I just opened the box to photograph the contents. See my other listings for a Dayton Teel vane pump that perfectly matches this pump motor.

I have for sell a Teel pump model 4RC46 0899. I have had this laying around for a while. Never been used but has some blemishes.

Just purchased this pump for my older boiler system. Used it for about a year then my boiler went out and had to have it replaced which came with its own built in pump. So pretty much I have a great condition pump here for fraction of what I paid which was $415.00.

NEW TEEL / DAYTON SUBMERSIBLE CENTRIFUGAL 110 V PUMP . MODEL 1 P 808 A. I PURCHASED FOR MY MARINE WATER COOLED AIR CONDITIONER BUT SOLD BOAT & NEVER USED OR INSTALLED.

This pump came from a factory closing sale...appears to be in new condition (old stock).

This Dayton Teel 3P754 was bought new from Grainger and has sat on the bench unused for half a dozen years. It is new, but tarnished from sitting around. It is equivalent to the Procons Grainger sells now.

Dayton Neoprene Pump Impeller/Sleeve Assembly (new in box) I purchased a box of miscellaneous winemaking equipment, parts and gadgets, and this new-in-box impeller was among them. It is in as new condition, with no visual flaws, blemishes or defects observed. As far as I can determine, this impeller/sleeve assembly was manufactured in the USA by Sherwood, which is embossed into the rubber on the top side of the impeller and partially visible in one of the photos.