You are viewing a mil surplus double pole double throw waterproof switch with harness. Center is off position, down is an on position and up is a locking on position you have to pull out a little to toggle up and the same to shut off the upper position, pull out a bit and toggle down. The military paid over 300 dollars for this switch assembly.
You are bidding an a NEW, lot of C&K C & K Miniature Toggle Switch hardware, Aircraft Avionics. There are 4 types of hardware in this lot, lock washers, tab washer/locking ring, mounting flat hex nut, and nickel plated panel dress nut.
Total of 6 pieces, 2 position switchcraft toggle switches.Except for one the other five do not appearto have ever been used ...Two position, of which 3 lok- and three are non lokPlease view photos
New "brass bullets" for the locking mechanism on your vintage Unisaw tilt and elevation shafts. Original "bullets" can get mushroomed and worn.... will not effectively lock the shafts in postion when the center hand knob is tightened.
Replacement threaded shafts for the center lock knobs on the UNISAW handwheels. This is a "new" machined shaft, for either the early style "wedge" lock or the later style "brass bullet" lock system behind the center knob at either the tilt or elevate handwheel on your vintage Unisaw. Now we have improved them even more.
used set of locking clamp pliers one carr-lane and two various others see pictures for size and condition good general condition expected wear and use on thesethe large clamp has a threaded adjuster that is slightly bent thus gets a little hard to adjust but does adjust
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.
