This is a cast idler pulley for the backside of a 3L, 4L or A series V-Belt. It measures 5 3/4" (5.75") OD with a 5/8" (0.625") wide face. The hub is on ball bearings and has a 1/2" (0.5") ID bore and the hub is 3/4" (0.75") deep.
Pulley / Sheave Reducer Sleeve to reduce a 3/4" Bore Pulley, gear, sprocket, wheels,etc. to fit a Small Gas Engine / Motor with a 1/2" Shaft with a 3/16" Keyway slot Length is 3"
Other than chipped paint the pulley and bushing are in very good condition. 9 inch od with a 1 3/8 id SK bushing. If I receive your payment by 3 PM PST I will ship the same day via 1 to 4 Day Priority Mail.
AS PICTURED Cable or Rope Steel Pulley 4" Diameter 5/8" id with needle bearings , 3/8" Cable or Rope , Were used for wire guides at electrical wire mfg.
Sold Elsewhere as the CWS2 for $1645, we sell the same model for $1225. This particular machine was used one day and was traded in for larger WS2 machine instead. So this machine has a few minor scratches from the wire going through, but still like new and under warranty.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.