pulley bearing for sale, brand-new and used.

McKissick Construction Block Model 612 - 6" / Double Pulley - Roller Bearing / 10 Ton Capacity. This block is new and unused, but has been in storage for approximately 25 years. It shows signs of handling and storage.

AG2421-A AETNA IDLER PULLEY Generally used as tighteners or direction changers; available for all standa

SPINDLE PULLEY NOT MOTOR! REF 5 1/4, 4 1/4, 3 1/16, 2 1/8 STEPS FOR 1/2" BELT RODE ON 5/8 SHAFT WITH DOUBLE KEY SPLINE THIS PULLEY IS IN VERY NICE CONDITION THRU-OUT REMOVED DISH PLATE AND BEARING STILL SPINS FREELY HAS "SPIT" SOME GREASE OVER THE YEARS. GOOD SPLINE KEYS.

KO Lee 11 Brown and Sharpe Taper Center w pulley for Cutter Grinder $12 shipping to USA

Grinder Spindle Body and Bearing Sleeve. These are newThey were never installed. 1&1/4 dia for pulley3/16 key

KO LEE #11 Brown and Sharpe Taper Drive Center for Tool and Cutter Grinder + Nice clean with very smooth turning bearing, looks to have seen little use, if any Also includes; B2055H3 (6”) V-Pulley

Tool Grinder Attachment Work Sharp WSKTS-KO Tool Gri

CMI RC112 DOUBLE-ENDED PULLEY Stainless steel sideplates, 2 3/8 inch aluminum sheave, sealed-needle bearing and stainless steel axle. 5/8 inch rope capacity. 8,500 pound (37.8 kN) minimum breaking strength (MBS) Condition: New

CMI RC106 DOUBLE-ENDED "CABLE-ABLE" PULLEY Stainless steel sideplates, 2 3/8" Steel sheave, sealed needle-bearing and stainless steel axle.5/8 inch cable capacity 8,500 pound (37.8 kN) minimum breaking strength (MBS) Condition: New

1941 10" Montgomery Ward (Logan) Deluxe model (ball bearing spindle) on cast iron legs with chip tray. Power cross feed and full set of change gears. It had a tooth broken on the pulley gear, which has been replaced with a new gear from Logan.

Tricks & Secrets of Old-Time Machinists: Hints and Kinks Provided by the Readers of American Machinist Magazine in 1912, 1918: Volume 4, originally published in American Machinist Magazine, compiled, edited and published by Lindsay Publications, Bradely, Ill., 2011. 5 1/2 x 8 1/2 paperback, 96 pages. ISBN 1-55918-398-5.

Arbors and Work Holding Devices: A Treatise on the Appliances Used for Holding Work for Turning, Boring and Grinding, Machinery's Reference Book No. 120, by the editors of Machinery magazine, The Industrial Press, New York, NY, 1914. Reprinted by Nation Builder Books, Leesburg, VA, 2000.

X2 mini mill belt drive conversion kit mbbilici DOT com Best belt selection and super precision pulley belt bearing surface, Ergonomic unique design spindle lock, Completely handmade, custom manufacturing. Private production to the customer for different X2 model mini-mills (sufficient to establish contacts for it). Amicably unlimited support for many years.

This item is being re-listed because the previous buyer changed the ship to address 3 times and wanted it shipped to an address different from the one shown on his PayPal account. We will ship only to a Paypal Confirmed address. This auction is for one very hard-to-find Derbyshire Mass.

You will be getting ABEC-7 Bearings that are shrink fit to cu