Pulley / Sheave Reducer Sleeve to reduce a 3/4" Bore Pulley, gear, sprocket, wheels,etc. to fit a Small Gas Engine / Motor with a 1/2" Shaft with a 3/16" Keyway slot Length is 3"
This auction is for the Very Heavy Alloy or Pot Metal wide pulley as pictured. It is about 6" diameter 5/8" bore with a key slot on 1 side only. The edge is about 1 1/2" wide outside and 1 1/8" wide for a flat belt Wear and Tear Dust and dirt but in good working condition.
Please read carefully before you bid/buy Auction for: 2 Items Pulley 20 Teeth bore diameter 1/4" Timing Belt 396.24mm/15.6" length, 15 mm width Reducing Ratio 1:1 used for same ratio transmission Other belt length are available or for any custom belt length please contact us For full specif
Up for auction I have 2 Browning Sheave Pulleys. The first is a 2Bk45 Pulley 2 groove, the second Is a smaller single groove pulley, however I cannot make out the part number. It appears to be A617 or 4617.
This is a 3" Pot Metal or alloy Motor Pulley with a 1/2" diameter bore takes 1/2" wide belts. It mounts with a set screw that is inside the pulley (under the belt) . The pulley is about 5/8 " thick.
This is a 2" Pot Metal or alloy Motor Pulley with a 1/2" diameter bore takes 3/8" wide belts. It mounts with a set screw that is inside the pulley (under the belt) . The pulley is about 11/16 " thick.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.