3 8 aluminum rod for sale, brand-new and used.

24736 New-No Box, Metal Craft TYAL1000 Aluminum Support Rod, 39-3/8" Length, 3/4" Width, 3/4" Height. Item is New, unused, no factory packaging. Austin Surplus SKU: 24736 Location: GRG-R01-P16-S04-0006906

[ Dayton 1/2 HP 20-1/2 ft 1725 RPM 115 V Upright Sump Pump

Warehouse Closing Down Sale! Retail Price: $600 Pressure Washer Pump, Shaft Dia. 3/4 In., Inlet Port (In.) 3/8 F, Discharge Port (In.) 3/8 F, Needle/Ball Bearings, Max.

Contact Wheel & Flat Platen “D-D Work Rest” for Bader II & III Knife Maker Belt Grinders Work Rest Includes: -Work Rest for Contact Wheel and Flat Platen with 2-3/8” x 1/2” cuto

Total System “D-D Work Rest” for KMG Knife Maker Belt Grinders (Since I don’t own all types of grinders, for display purpose only the Total system is shown mounted on my Bader Grinder)

Total System “D-D Work Rest” for Wilton & Jet Square Wheel Knife Maker Belt Grinders Work Rest Total System Includes: -Large Work Rest for Contact Wheel / Flat Platen with a 2-3/4” x 1/2” cutout to wrap around the belt

Contact Wheel & Flat Platen “D-D Work Rest” for Grizzly G1015 Knife Maker Belt Grinders Work Rest Includes: -Work Table 1/4" plate steel with 2-3/8” x 1/2” cutout to wrap around the belt

Small Wheel “D-D Work Rest” for KnifeDog and Wilmont Small Wheel Holder, Knife Makers Belt Grinder

Total System “D-D Work Rest” for Bader I, II and III Knife Maker Belt Grinders Work Rest Total System Includes: - Work Rest for Small wheel holder

Contact Wheel & Flat Platen “D-D Work Rest” for KMG and G2 Knife Maker Belt Grinder (Since I don’t own all types of grinders, for display purpose only the Work Rest is shown mounted on my Bader Grinder)

Contact Wheel & Flat Platen “D-D Work Rest” for JL Knife Maker Belt Grinders (I don’t own a JL Grinder so all photos are taken with the JL Work Rest mounted on my Wilton Grinder) Work Rest Includes: -Work Rest with 2-3/8” x 1/2” cutout to

Small Wheel “D-D Work Rest” for KMG Knife Maker Belt Grinder Small Wheel Holder (For display purpose only the KMG Holder is shown mounted on my Bader Tooling Arm)

TOUCH PROBE 3/8 SHAFT 2 wire input Made is USA

TOUCH PROBE

SHAFT ALIGNMENT DIAL INDICATOR ROLLER CHAIN JIG MILLWRIGHT & MAINTENANCE IT'S ON EVERY MILLWRIGHT AND MAINTENANCE TOOL LIST A TRUE CRAFTSMAN MUST HAVE AT LEAST ONE IN THEIR TOOLBOX NOTE "TWO ARE NEEDED FOR REVERSE AND NEW METHOD OF ALIGNMENT PROCUDURES OVER 35 YEARS OF EXPERIENCE WENT INTO THIS ONE 6061 AIRCRAFT ALUMINUM

This is a newly machined 47/37 transposing gear set which converts your 8 TPI lead screw to a 2.5 mm pitch. The thread’s crest-to-crest or lead error is only 0.02% or about 0.0025 inch for a one-foot long threaded rod. The transposing gears are under 3 inches in diameter leaving lots of room for closing the gear cover.