AIR TABLE ACTUATOR, PHD BS08 1X3 BORE, 1 3/8" STROKE, 3" THE TABLE SLIDES ON A LINEAR BALL BEARING GUIDE ROD DIAMETER, 1" PORTS, 1/4" NPT CUSHIONS ON BOTH ENDS OF THE CYLINDER MAX P.S.I., 150 AIR THE TABLE HAS
This is a brand new, much improved, finger knob for the tightening the rear clamp on your vintage UNISAW fence. This is a easy-to-install replacement knob for tightening the rear clamp's J-hook found on the early style Delta
New "Saturn" ball knob for the locking lever on your Delta Unisaw fence. THIS AUCTION IS FOR THE KNOB ONLY. SEE MY OTHER AUCTION FOR THE KNOB AND THE STAINLESS STEEL SHAFT.
A NEW "Saturn" ball knob and stainless steel threaded shaft for the locking lever on your Delta Unisaw fence. THIS AUCTION IS BOTH THE KNOB AND THE SS SHAFT. IF YOU WANT ONLY THE KNOB, SEE MY OTHER AUCTION SITE.
Special listing consisting of one each of the following 304008-1 3/8-12 acme rod, RH, 1 start, low carbon, oil finish 12" long $4.60 304006 3/8-12 anti-backlash nut, delrin $12.50 302068 5mm x 3/8 aluminum beam, flex coupler, blue $9.00 Total $26.10 Ident Brand Description Length Used in:
FREE SHIPPING TO THE LOWER 48! Fixture Plates: All plates are 1.375" thick, dual layer aluminum fabrications, anodized for surface toughness. Laser engraved reference scales provide 1/8" increments
Item ...................... Qty.1 aluminum rod per bid Manufacturer ...... OSBORN Threaded on one end and has a 5/32" hole on the other end Condition .............
This is for one sets of two hole flange pins shown They are made of 6061 aluminum They will work on hole size 3/8" to 7/8" up to 1 1/2" thick They have 3/8-16 steel threads and 45 degree taper bdarchery@hotmail.com
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.