100 @ 1/4 x 1 1/4 HWH Original Tapcon Concrete Anchor Screws Hex head slotted screws Self tapping, just drill the proper size hole and thread them in. You just have to drill a 3/16 hole with a masonry bit which is INCLUDED Note the boxes are water damage but the bits are corrosion resistant. I have opened the box and counted the contents for verification. I use these all the time and there great if you use a good hammer drill and bit.
P2000 RIGID FOAM INSTALLATION SCREWS WITH WASHERS (245). THESE SCREWS ARE SELF TAPPING FOR USE IN METAL STUDS BUT COULD BE USED ON WOOD OR OTHER MATERIAL. These screws were designed for the P2000 rigid foam insulation but could be used on any rigid foam material.
MOTOR PLUS CAPACITOR! This motor is a direct replacement for many Rheem, Ruud, and Weatherking Air Conditioners and Heat Pumps. Mounts with 10-32 X 7/16" self-tapping machine screws in the motor end boss or band-around bracket.
CUL-14816 8X1 RWHTS SQ DR ZP. Sheet Metal Screws (Self-Tapping Screws) are threaded fasteners with sharp threads to cut into materials such as sheet metal, plastic, or wood.
CUL-14828 8X1-3/4 RWHTS SQ DR ZP. Sheet Metal Screws (Self-Tapping Screws) are threaded fasteners with sharp threads to cut into materials such as sheet metal, plastic, or wood.
The FastenMaster ThruLok 24-Piece Screw Bolt Fastening System can be used for carrying beam and decking post connections. The system includes 24 screws, nuts and washers for your convenience. Self-drilling and self-tapping design.
Lot of (1200) slotted / indented hex washer head self-threading sheet metal screws. These zinc plated screws are size #8 and are 1" in length with a 1/4" hex. The type A screw is designed for use in sheet metal from .015 to .050" thick with pre-drilled or punched holes as well as some plastics, impregnated plywood, and other materials.
Lot of (2000) slotted / indented hex washer head self-threading sheet metal screws. These zinc plated screws are size #6 and are 3/4" in length with a 1/4" hex. The type A screw is designed for use in sheet metal from .015 to .050" thick with pre-drilled or punched holes as well as some plastics, impregnated plywood, and other materials.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.
