3/4 threaded rod for sale, brand-new and used.

Size M1. Body diameter 12 mm, length 18 mm. Recommended rod size: 0.83mmImportant - use LOW cutting speed 20-90 m/min for thread rolling (or roll manually)

Size M2.2x0.45. Body diameter 25 mm, length 25 mm. Comes with a small caliber.

Extended 5C Collet Stop Set for Hardinge Lathes, Chuckers, Mills, CNC, and others. Note: Easily and Accurately locate parts 7/8” diameter or smaller in any standard 5C collet with internal and external threads (Extender Tube I.D. is .900") 5C Collet Stop’s and Extender Tubes fit inside a 5C spindle with a minimum 1-1/16” I.D.

FOR SALE: ONE SET OF TWO ALUMINUM 6061 MACHINIST CLAMPS. CLAMPS ARE SHOWN IN A CNC MILL, BUT THEY ARE GREAT FOR ANY MACHINE OR OTHER USE WHEN YOU NEED TO HOLD. CLAMPS MEASURE 1.75" LONG, .750" WIDE, AND 3/8" THICK AND ARE VERY STRONG.

FOR SALE: ONE SET OF TWO SOLID BRASS MACHINIST CLAMPS. CLAMPS ARE SHOWN IN A CNC MILL, BUT THEY ARE GREAT FOR ANY MACHINE OR OTHER USE WHEN YOU NEED TO HOLD. CLAMPS MEASURE 1.875" LONG, .875" WIDE, AND 3/8" THICK AND ARE VERY STRONG.

RBF Products Adjustable 5C Collet Stop * Up for sale is (1) RBF Products Adjustable 5C Collet Stop. * Condition = New * Made

RBF Products Adjustable 16C Collet Stop

RARE SELF-CENTERING VISE/VICE TOOL (Type Mechanism in Hermes Vises / Engraving Vises / Scissor Lifts) SCISSORS LIFT MECHANISM PARTS, DIY New old stock (NOS), minor surface discoloration due to storage. Rare Solid Steel Self-Centering Vise Tool Mechanism Parts Set. This is the same general type of self-centering mechanisms found in the superior Hermes Vises, other Engraving Vises, and small Scissors Lift Platforms.

This auction is for 1 Standard 6" Billet aluminum Machined vise stop. (DIMENSIONS FOR FITMENT) This vise is designed to mount onto the back of a 6" standard vise. This means brands like KURT, GLACERN, and any other standard 6" vise with 3.875" spacing from center to center of holes, and uses a 1/2-13 thread.

var itemNumber = window.ebayItemID ?

PlasmaHelper Plasma Torch Standoff. Keeps your tip off cutting surface, provides stability and a good edge to place against a guide. Threaded 1/4" x 20 so you can make your own attachments if you need.

DREX9 US600-01 Dremel Ultra-Saw 4-Inch Wood Flush Cut Wheel

May be used as a spindle-adapter for a wood lathe from LatheCity Included: Morse Taper #2 (MT2) to 1"-8 TPI (x1.5" thread length), steel, 1/4-20 drawbar, RH threads + nut and washer

May be used as a spindle-adapter for a wood lathe from LatheCity Morse Taper #3 two in one

PASCO ME-9376B UNIVERSAL TABLE CLAMP

LABORATORY JACK 12 X 14 CM Healthcare Life Science Lab Supplies Frames, Support