4 muffler for sale, brand-new and used.

This is a nice reproduction ball muffler for a gas engine. It was cast aluminum and someone has smoothed and polished it. They did a really nice job and would look really nice on your restored engine.

This is a reproduction cast aluminum cone type muffler for a hit and miss or throttle governed gas engine. These were commonly used on Hercules and Economy engines and several others. They look and work good on any engine they fit on!

Here is a muffler from a vintage gasoline engine. This collectible gas engine muffler measures about 4-1/2" around and 3" wide with a 1" male pipe thread nipple attached. Looks to be in good condition with only surface rust and some small dents though at some point there has been a 1" x 3/4" bell reducer added.

Here is a vintage muffler that may have been from a snowmobile, tractor, gas engine or antique vehicle. This 9" long x 5" round muffler body has a 1-1/2" inlet flange with two 3/8" bolt holes, one slotted, about 2-11/16" apart mounted at about a 30 degree angle to the main body and a curved 1-1/2" outlet that is about 5" long. There is a 1/4" mounting stud on one end and a hoop approximately half way on the opposite side.

Here is a muffler from a vintage gasoline engine. This collectible gas engine muffler measures about 4" around and is about 3" thick with a 1" male pipe thread nipple attached that is about 4-1/2" long. Looks to be in good solid condition with only surface rust and some pipe wrench marks.

This is an original cast iron ball type muffler for a hit and miss or throttle governed gas engine. These were commonly used on Economy engines and several others. They look and work good on any engine they fit on!

Muffler is approx. 5-5/8” in diameter and has a 1-1/4 NPT inlet. Excellent condition for its age, has a few shelf scuffs but no dents or dings.

An affordable reproduction ball muffler used on many early small engines. Stop wasting time looking at dented, rusty, used mufflers with big price tags, these are proudly made in the USA just like the originals. The muffler 4 inches in diameter with a 3 inch long inlet and has the inner baffle plate.

Shusher Muffler 103055 1" Pipe Thread I believe this is for a sears Suburban but they were used on some Wheel Horse and Bolens

This is a very old style muffler for a stationery engine, such as a small hit and miss engine or a Briggs & Stratton or similar. I do not know the actual application. The thread opening looks to be 3/4" pipe thread.

Norgren MQ006A Coalescing Muffler 3/4" port

Here is a muffler that is for about a 2hp to 3hp Alamo, Rock Island or Empire Engine. Check out the pictures and see if you need it. Original Part numbers 4075 and 4074 7-3/4" in diameter 1-1/4" pipe mounting The threads don't look perfect but it screws onto a pipe just fine NO Cracks, Breaks, or Welds that I can see or know of.

Fits Models: Exmark Lazer Z Kohler CH25-68543, CH25-68606, CH25-68695 and CH730-0003 Specs: &n