New American Rotary panel with a used idler motor. You do not have to pay for the converter until you see and hear it run. I am located just Southwest of downtown Los Angeles near USC.
Purchased a few years ago to run a flatbed CNC router and air compressor - we changed buildings and had access to 3-phase and didn't need the converter anymore. Just taken out of the box for pictures. Never installed and never used.
New converter panel with a new Lincoln idler motor, please note the factory protection is still on the shaft of the motor. If you would like you do not have to pay for the converter until you see and hear it run. I am located just Southwest of downtown Los Angeles near USC.
Basically a brand new Rotomaster Phase converter that we installed and only used one time because our service was too small to handle the load in our backwoods location. We did not have enough service. This unit will power up 10 to 15+ hp to my knowledge.
For Sale is a Kent 1340 Gap lathe which when the gap is removed will swing over 18". I bought this machine new and have only put about 20 hours on it. The paint is like new, it is powered by 220 SINGLE PHASE which can be run off of house current without using a phase converter.
NORTHTECH cyclone dust collector & lots of spiral pipe duct. Attention cabinet makers, and wood workers. Here is a NORTH TECH 2 stage cyclone dust collector made in 2002.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.