40 hp phase converter for sale, brand-new and used.

phaseconverter_template_ver1 var lastID = 0; function SelectImg(id) { if (lastID > 0) { document.getElementById(lastID).className = "thumbnail"; } document.getElementById(id).className = "thumbSelected"; document.getElementById(0).src = document.getElementById(id).src; lastID = id; } function LoadTrigger() { SelectImg(1); } window.onload = LoadTrigger; function MM_swapImgRestore() { //v3.0   var i,x,a=document.MM_sr; for(i=0;a&&i

I am selling a 40 HP Phoenix phase converter. It is in like new condition. All manufacturers instructions and wiring is included.

Hi folks, We purchased this 230 - 460 V phase converter which was needed to replace an existing converter that was determined to be bad. Upon further investigation, there was nothing wrong with our current setup, and we were able to fix the problem without using this new converter. We set it up on a skid that could be picked up with a forklift, however we never hooked up any wiring from the motor, everything was simply mounted and then nothing ever done with it.

New American Rotary panel with a used idler motor. You do not have to pay for the converter until you see and hear it run. I am located just Southwest of downtown Los Angeles near USC.

Purchased a few years ago to run a flatbed CNC router and air compressor - we changed buildings and had access to 3-phase and didn't need the converter anymore. Just taken out of the box for pictures. Never installed and never used.

New converter panel with a new Lincoln idler motor, please note the factory protection is still on the shaft of the motor. If you would like you do not have to pay for the converter until you see and hear it run. I am located just Southwest of downtown Los Angeles near USC.

Basically a brand new Rotomaster Phase converter that we installed and only used one time because our service was too small to handle the load in our backwoods location. We did not have enough service. This unit will power up 10 to 15+ hp to my knowledge.

NES1-004LB Inverter, 200-240 volt, 3 phase, 1/2 HP, 2.6 Amps

For Sale is a Kent 1340 Gap lathe which when the gap is removed will swing over 18". I bought this machine new and have only put about 20 hours on it. The paint is like new, it is powered by 220 SINGLE PHASE which can be run off of house current without using a phase converter.

40 HP ROTARY PHASE CONVERTER, BRAND NEW, MADE BY U.S. INDUSTRIAL AUTOMATION, COMPLETE WIRING DIAGRAMS WITH OPTIONAL INSTRUCTIONAL VIDEO. 10 YEAR WARRANTY, 30 YEARS EXPERIENCE.

This unit is from a military outpost, it appears to be in good condition but I do see some sand residue in it that looks like desert sand. The release paper says that the unit is functional but we are not able to test it to confirm that. On the unit there is a hand written tag that reads "Needs CPCVX" bu I dont know what that is.

TOOT PERFORMANCE Specs: VOLTS: 208-230/460 ENCL.: TECF MAX AMB: 40 C TIME RATING: CONT, KVA CODE: G NEMA F.L. EFF, : 90.2

Carpenter electric Equipment phase converter. 40 HP 230 Volt 3 phase output. With fuse box.

Brand new factory sealed!!! POWER FLEX 4. 22A-D6P0N104!!!

This was acquired through a federal bankruptcy sale. It was found in the original manufacturer supplied shipping crate. It looks to be new.