5 inch pulley for sale, brand-new and used.

Aluminum Mobile Scaffold Rolling Tower 6'H x 6'L x 29"W with Aluminum Hatch Deck 750 LBS Load Rating

New 4 MFS Scaffold Rolling Towers 29"W X 6'H Deck with U Locks

12 Feet Standing High Scaffold Rolling Tower with 2 Hatch Decks Guard Rail CBM NEW Scaffolding Rolling Tower you can Standing at 12 Feet High. With Guard Rail, Two Hatch Decks, and Outriggers.

NEW Scaffolding Rolling Tower you can Standing at 12 Feet High. With Guard Rail

We carry a wide selection of scaffolding and aluminum patio furniture products, ranging from backyard dining table sets,

SHIPPING INSURANCE IS INCLUDED.

This is an excellent original Detroit Model G 5 feed mechanical lubricator for an early prairie tractor, automobile, or hit and miss gas engine. It was commonly used on the early single cylinder Rumely tractors and several others. It is in excellent condition with no cracks, breaks, or repairs of any kind.

This is a very hard to find original Waters 1 1/4 inch governor. These were commonly used on steam engines as well as a few gas engines. It was made by the Waters Governor Company in Boston, Mass.

ANTIQUE FLAT BELT PULLEY WHEEL FINISH VERY RUSTY NO CRACKS has 502 t cast in one spoke 23 INCHES IN DIAMETER X 4.25 INCHES WIDE SHAFT SIZE IS APPROXIMATELY 1 3/8 INCH WITH KEY SLOT

An antique Hit & Miss Engine......... 12" wood & Cast Iron & Steel Pulley offered as found in very good condition........ 5 1/2 inches wide had a 1 1/4 inch shaft hole.....

Large Pulley will take 5/8 inch rope. Tandem 2.25 inch sheaves as shown. Overal size is about 4 inch.

BRAZILIAN GAS GRILL FOR BBQ NSF APPROVED 38 Brazilian skewers of 28"

BRAZILIAN GAS GRILL FOR BBQ NSF APPROVED 47 Brazilian skewers of 28"

90° corner pulley 1/2" conduit compression connection

Product Number 60XL037-6A0.375 (60XLB037) Teeth 60 Tooth Style (XL) 1/5 pitch Type 6A (with Hub) Hub O.D. 1.76" Bore Type Finished Bore Pitch Diameter (in)