For auction is a HITRAN control transformer from a CSI Electronics FM broadcast transmitter we are tearing down. This transformer has an input of 208 or 240 Volts with +10 & -10 Volt taps with an output of 25 Volts, it was powering the controller for the filament of a 8877 tube in an American 60 Hz. application.
SAFETY ISOLATION TRANSFORMER APPLICATION Open single-phase safety isolating transformer designed and tested according to norm EN61558-2-6. Separate insulated windings and protected against dust, humidity and corrosion through complete impregnation in heat tempered varnish. For fixed installation in cabinets
The 500VA toroidal transformers are commonly used in the noise sensitive equipment or high end audio products. They are specially designed to work on all standard 115V or 230V at 50Hz or 60Hz. These transformers have heavier gauge wires then the normal requirement to avoid the copper lost during the full power output.
The 500VA toroidal transformers are commonly used in the noise sensitive equipment or high end audio products. They are specially designed to work on all standard 115V or 230V at 50Hz or 60Hz. These transformers have heavier gauge wires then the normal requirement to avoid the copper lost during the full power output.
The 500VA toroidal transformers are commonly used in the noise sensitive equipment, high-end audio products, stepper motor supply, or servo motor supply. They are specially designed to work on all standard 115V or 230V at 50Hz or 60Hz. These transformers have heavier gauge wires then the normal requirement to avoid the copper lost during the full power output.
The 500VA toroidal transformers are commonly used in the noise sensitive equipment, high-end audio products, stepper motor supply, or servo motor supply. They are specially designed to work on all standard 115V or 230V at 50Hz or 60Hz. These transformers have heavier gauge wires then the normal requirement to avoid the copper lost during the full power output.
The 500VA toroidal transformers are commonly used in the noise sensitive equipment or high end audio products. They are specially designed to work on all standard 115V or 230V at 50Hz or 60Hz. These transformers have heavier gauge wires then the normal requirement to avoid the copper lost during the full power output.
The 500VA toroidal transformers are commonly used in the noise sensitive equipment, high-end audio products, track light, stepper motor supply, or servo motor supply. They are specially designed to work on all standard 115V or 230V at 50Hz or 60Hz. These transformers have heavier gauge wires then the normal requirement to avoid the copper lost during the full power output.
The 500VA toroidal transformers are commonly used in the noise sensitive equipment or high end audio products. They are specially designed to work on all standard 115V or 230V at 50Hz or 60Hz. These transformers have heavier gauge wires then the normal requirement to avoid the copper lost during the full power output.
For your consideration is the General Electric model 450 Voltage transformer also known as potential transformer These are perfect for metering or instrumentation as they have a 750VA rating (Deg C. 30 & 500VA at 55 Deg. C) the ratio is 288:120 they are designed for 277 V allowing the 2.4 ratio to be programmed into most PLC and KWH meters.
This is a Stancor P-6298 105/115/125V to 115V line adjusting isolation transformer in excellent condition. The input voltage is switch selectable. Use it to correct for power line variations.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.
