ball bearing 1/2 inch for sale, brand-new and used.

About us Shipping Payment

About us Shipping Payment

About us Shipping Payment

MRC R16Z, R16 Z, Small Inch-Size Ball Bearing, 1" ID x 2" OD x 1/2" Wide; Single Seal; No Snap Ring; Single Row Radial Steel Bearing. This sale is for one. I will ship 24 hours after payment has cleared.

R14ZZ Sealed Ball Bearings 7/8" x 1 7/8" x 1/2" Lot of 10 Bearings

**brand new still in box. **BOX MAY SHOW WEAR DUE TO STORAGE Sealmaster MP-35 Pillow Block Ball Bearing, Non-Expansion Type, Medium-Duty, Regreasable, Setscrew Locking Collar, Felt Seals, Cast Iron Housing, 2-3/16" Bore, 2-3/4" Base to Center Height, 7-1/4" Bolt Hole Spacing Width, ±2 degrees Misalignment Angle

8 in. Bench Mount Drill Press, 5 Speed

Two Matching Rotators. These are heavy duty. The bearings rotate smoothly.

HAVE TOOLS TO GRIND ?YOU ARE VIEWING A COMPLETE PACKAGE BUILT BY CUTTERMASTER SINGLE PHASE OPERATION INCLUDED FULL SET OF 5 C COLLETSAIR BEARING WITH STYLUS DRILL SHARPENING FIXTUREBALL RADIUS GRINDING FIXTURE TAP AND COUNTER SINK GRINDING FIXTURECAMS FOR DRILL TAP COUNTER SINK COUNTER BORE AND ROUGHING END MILLS INCLUDED

Thousands of Used Metalworking and Plastic Machines & New Machine Tools Photos, Full Descriptions and Prices - Fast & Easy

"Occupying a floor space of just 65" x 32.5 inches ( 1650 x 825 mm) and with an 18" x 6" (450 x 150 mm) table capable of moving 19 inches (480 mm) longitudinally and 6.75 inches (170 mm) in traverse the 540 grinder was ideally suited to most smaller toolroom jobs. The cross slide was supported on two V ways with a feed rate of 0.007" to 0.07" (0.175 to 1.75 mm) per minute at each reversal of the longitudinal stroke.

Automatic Pivot Style Band Saw Model S-20A

Tricks & Secrets of Old-Time Machinists: Hints and Kinks Provided by the Readers of American Machinist Magazine in 1915 and 1916, Volume 2, originally published in American Machinist Magazine, compiled, edited and published by Lindsay Publications, 2008. 5 1/2 x 8 1/2 paperback, 96 pages. ISBN 1-55918-371-3.

These plans are to build a heavy duty sawmill. The saw is a fresh design based on a simple idea that the saw must be extremely strong, very accurate, easy to align and maintain, and cost efficient to build. It was built to cut Mesquite, a very hard wood, so it will make short order of any kind of wood you want to saw.

5 chucks 2 3/8 including jacobs. Other is 10mm 1 craftsman 1/2 inch 2 ball bearing inserted chuck quick adapter

used but works great setup for bridgeport mill ,but collet will come off for use in drill press ,cap.0-1/2 inches drill chuck , shippes to the lower 48 states only, it's a real work horse good luck in the sale ,chuck key comes with it