I have had this for a couple years and used it exclusively for doing resin infusions in my shop. I ALWAYS used a resin trap and it is obvious when you look in the inlets. It has no problem pulling 28+" on a 3' x 5' tool.
Item Condition: This pump is in good working condition with some wear and use. The top plate is a bit dented and there are some scuffs and scratches. The back electrical plate is missing.
SIMADRE CT60A is made by international most advatageed invert technology. The 50/60Hz frequence is inverted to high frequence (frequency is over 100KHz) by V-MOSFET , then setp down voltage and recitificate current. The inverter power supply generates powerful DC welding current through PWM technology.
******The warning light comes on when switched to plasma cutting or MMA mode, I have never used or tested the TIG mode but the light is not coming on if its on this setting when turned on. I had a problem before with the warning light coming on but it went away on its own and worked fine for several months. The light may go away again on its own or may have something loose inside or may need to be serviced.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.