THIS RJ33-13L CHUCK IS IN GOOD WORKING CONDITION. IT WILL TAKE UP TO A 1/2 INCH BIT AND HAS A JACOBS 33 TAPER FOR YOUR ARBOR. IT WAS FROM AN OLD DELTA DRILL PRESS.
You are bidding on (1) INDUSTRIAL HIGH QUALITY MACHINIST CHUCK MODEL #F16KD made in Japan. It is an exact replacement for the Jacobs Model 36KD with a #3 Jacobs taper mount with posi-slot, which can be used with a mill, lathe, drill press or most Milwaukee Heavy Duty Hole-Shooter drills . The chuck has ground jaws for superior tool holding, 3/16"(4.5mm) TO 3/4"(19mm) holding capacity and a special coating on the entire outside of the chuck to help prevent rust and oxidation!.
used but works great setup for bridgeport mill ,but collet will come off for use in drill press ,cap.0-1/2 inches drill chuck , shippes to the lower 48 states only, it's a real work horse good luck in the sale ,chuck key comes with it
This is a good chuck with key. Key is not stripped and the jaws are in good shape, not all rounded off. It says it has a 33 taper and is a 1/2 inch capacity.
A GOOD USED MODEL SIZE SAME AS JACOBS S-K3C 5/16" PILOT FOR 5/8" OR 1/2" DRILL PRESS CHUCK KEY FIT JACOBS CHUCK No.633C, 633D. Soft Steel Handles Limit the Potential for Dangerous Fracturing Under Excessive Load. Self-Ejecting Models with Spring-Loaded Ejectors Ensure Key Disengagement After Tightening.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.
