Flat Belt Pulley Hit & Miss Engine Cast Iron

US $1200

  • Annandale, New Jersey, United States
  • Jan 31st
This is a cast iron bolt on style flat belt pulley. Unknown manufacturer & is unmarked. The width of the flat face is 8 & 5/16th. The pulley is 10 inches in diameter. It has three mounting bolts which mount on every other spoke of a flywheel. The bolt are spaced at 4 & 5/8th centerline to centerline. It has a 4 inch diameter center hole in the mounting side of the pulley which will go over most any engine crank shaft. Beyond the center hole is another ridge in the rear face of the pulley that is 6 & 7/8 inches wide. These two ares are perhaps 3/16th above the remainder of the pulleys mounting surface. The Pulley has been cleaned with a coating of boiled linseed oil, to protect it from weather.It is being sold without warranty, without return or refund. I will ship this item by USPS, UPS or Fastenal. I will quote shipping cost based on zip code & buyer pays the shipping cost.  May be picked up in Annandale NJ 08801 at no cost to buyer. The buyer may also make there own shipping arrangements.
Condition Used :
An item that has been used previously. The item may have some signs of cosmetic wear, but is fully operational and functions as intended. This item may be a floor model or store return that has been used. See the seller’s listing for full details and description of any imperfections.
Seller Notes Old, Clean, Could use additional cleaning, Covered with Boiled Linseed oil,No crack, breaks, welds, Etc. Can be used as is without any problems. Does not have needed bolts to bolt to flywheel.

Directions

Similar products from Engines

People who viewed this item also vieved

By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.

Accept All Cookies