floor conduit for sale, brand-new and used.

50 Ft Cable Pullers Conduit Electrical Pipe Feeder Push Rods Rod Nylon Fish Tape If you're looking to pull short runs of electrical wire through conduct, you're sure to find this useful. Nonconductive nylon construction for use in telecom, electrical, wall, and floor conduitSafer pushing and pulling in occupied duct and panel boxes1-1/2" bend radius200 lb. pull strengthInterchangeable terminals and eyeletPIDHBFBB94244

These electric channel outlets were installed in a local dance club. They were placed down both sides of the dance floor at the top front next to the ceiling. There were about 30 different Par 36s mounted to the channels with a single screw, which is still attached.

Conduit bender Truper -thin wall conduit bender 1" (25,4 mm) -heavy wall conduit 3/4" (19mm) •Bends up to 90° •Ribber foot construction for bending on the floor •Made of dectile iron

This is 1x kil lark ecf-224 explosion proof flexible conduit 

This conduit was laid out on the floor at job site but never installed. Over 20 rolls available. The AFC Cable Systems 1 in.

GB Electrical 960 Conduit Bender-1/2" EMT CONDUIT BENDER, still in very good condition. Sold as is in the picture

3/4 INCH CONDUIT COVER, FORM 7

Caddy SCH24B Single Piece Strut Clamp for Cable/Conduit - 72 Pcs Fast and free shipping within 24 hours of receiving payment (excludes weekends and holidays) Make An Offer

Nice lot of 8, 1/2" emt conduit couplers with locking screws. Standard 1/2" X 1 1/2" long. Please see my other auctions for similar items.

Nice lot of 8, 1/2" emt conduit couplers with locking screws. Standard 1/2" X 1 1/2" long. Please see my other auctions for similar items.

This is for one good used 1 inch Myers Hub/water tight hub for 1 inch conduit.

Eight shoes for Greenlee benders and two 884 conduit support rollers. These are just the shoes, no saddles. Look at the photos closely for the markings, I have included what markings I found below.

This Current Tools 451 Hot Box (PVC Heater) allows you to quickly heat 1/2" - 4" PVC conduit, which enables you to custom bend the pipe to fit your job. Example: 2" PVC conduit will heat in approximately two minutes. Description Durable wheels for maximum mobility Full length door allows easy loading and removal of PVC conduit Manual operation 120 vac - 2300 watts - 20 amps Lighted ON/OFF switch Highly reflective interior for even heating.

You are bidding on 3 Klein pipe benders in very good shape. The sizes are 1/2", 3/4", and 1". Thank you for looking and good luck.

LIKE NEW CONDITION, BARELY USED BUYER PICKUP OR BUYER ARRANGED FREIGHT Gardner Bender B2000 Cyclone Electric Powered Conduit Bender for 1/2-Inch to 2-Inch EMT, Rigid and IMC Conduit Gardner Bender B2000 is a Cyclone electric powered conduit bender that does one shoe bends from-1/2-Inch to 2-Inch conduit. The Cyclone has the ability to make repeatable bends at the same-Degree. The horizontal and vertical positions allow the unit to create accurate offset bends.

This I believe is a LIDSEEN conduit bender part, I'll call it a saddle. This may fit other manufacturers also. This is a fabricated steel piece.