New Precision Take-up Bearing for South Bend 9" Model A,B,C and All 10k Lathes From ILION Industrial Services, LLC Please note that these precision ground bearings are all brand new, made in the USA. They are sold as a set of two thrust washers and one bearing as shown above and come with complete instructions for installation on your 9" workshop model A, B, C or the model 10k lathe.
Starrett 2pc Solid Nut Inside Calipers Flat Leg, GOOD CONDITION 1 each 3" Flat Leg, Solid Nut: made from a high-grade steel and well-finished. The legs are made of flat stock and are very durable. Calipers feature a hardened fulcrum stud and centrally located leg adjustment to assure smooth action.
Drill Chuck is screwed from the back to ensure it does not come out during high cutting loads All critical surfaces precision ground Made from alloy steel hardened to 54 - 56rc Jaws are hardened to over 60rc Balanced to 15,000 rpms Gage length is 110mm (4.3 inches) This unit can hold shanks from .019-.511 (.5-13mm) Rear thread for pull stud is M16 X 2.0 Wrench included MariTool Part# is BT40-APU13-110
Tool Holder accepts all ER32 collets Made from alloy steel hardened to 54 - 56rc Balanced to G2.5 at 20,000 rpms Concentricity is less than .0001 at collet face All critical tool holder surfaces precision ground Coolant through capability Gage length is 100mm (4.0 inches) Internal screw included Rear thread for pull stud is M16 X 2.0 MariTool Part# is BT40-ER32-100
Maritool ER-16-120 Collet Toolholder Accepts all ER16 collets Made from alloy steel hardened to 54 - 56rc Balanced to G2.5 at 20,000 rpms Concentricity is less than .0001 at collet face All critical surfaces precision ground Coolant through capability Gage length is 120mm (4.75 inches) Internal screw included Rear thread for pull stud is M16 X 2.0 MariTool Part# is BT40-ER16-120
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.