hydraulic pump rebuild for sale, brand-new and used.

&

You are looking at a Megatech Hydraulic Testing - Diagnosis - Repair - Rebuild - Fabrication table. This table has a Dayton 1hp 60hz 115V single phase motor powering a hydraulic pump with filter and reservoir. The table has a built in drain under the mesh top.

&

Up for sale is NOS, new old stock Vickers 2.5 GPM hydraulic vane pump. The model number is V110251 B 10. It has been setting on the shelf in my shop for some years but never used.

New Parker/Commercial Hydraulic Pump P50B478BYAK22-7CEJ17-1 Unit shows no sign of use and is believed to be new. Could possibly be a new rebuild. Please inspect photos.

brand new in package a seal rebuild kit with manual for the Greenlee 767 hydraulic hand pump starting with serial #ABM. this is the newer style pump with the rubber oil bladder. free shipping for within the united states...

The item available here is a remanufactured Oilgear industrial hydraulic pump that was remanufactured. It has never been installed since the rebuild, but unfortunately has sustained slight damage to the outer seal / bearing area and will most likely need that part repaired before being installed. It's being sold with a 14 day return policy from the date the item is shipped, but no return if the item is mounted.

For Your Consideration: Clark CY200LBD 20,000lb Capacity This Lift has been entirely redone. 453 Detroit Motor cost $6000 to have an in-frame rebuild, all belts and water pump are new, supercharger was rebuilt, starter is new. Transmission has been re-built with all new bearings, clutches, and a new torque converter.

Up for auction is a new Vickers Eaton hydraulic vane cartridge for rebuilding your pump. It will support many Vickers hydraulic pumps and many model numbers. Please refer to the Vickers part number in my listing to make sure it will work for you before bidding.

ATLAS - SC3001 Unit # 970 Ft. Lbs Crane Weight 2,480 lbs. Vendor Atlas 39,818 5.5 TON Horizontal Reach 17' 7" Model # SC3001 Load Chart Vertical Reach 28' Serial

NATIONAL 100 38/40 Knuckleboom Crane Unit # 987 Ft. Lbs / Ton Crane Weight 5,550 lbs. Vendor

&nbs

Vermeer 935 Brush and Log Chipper.Takes up to 9" Logs and puts out uniform chips due to Hydraulic Automatic Feed System and New Cutter Blades.Engine is just Rebuilt by us(new pistons,rings,pin bushings,bearings,valves,guides,springs,gaskets,seals;overhauled Starter,Alternator,Distributor,Carburetor,Fuel Pump).

Not sure what model this is. Its 115/203/230 single phase. 5000psi.

ENERPAC HYDRAULIC HAND PUMP This unit was removed from a shop and is in well used condition so you may need service or rebuild The hydraulic oil may be removed for shipping Used, cosmetically has some paint-off scratches/blemishes, rust, and is dirty Comes only as pictured so see/enlarge the pictures for more details

Oil pump was used in a Carrier 19C machine(size 7 compressor) with R-11 refrigerant and pumped R&O 68 Hydraulic fluid. Rebuilt/rewound installed for 11 hours before chiller was replaced, parted out and hauled away. Motor is 480v, part number KK04YZ-012.

cast iron 8" between ports shaft 1" diameter with 1/4" key inlet, outlet 1-1/2" NPT mount 6 3/8" screws 4.72" O.C. radius Shipping: