This Merritt Headache Racks fits a conventional tractor without a sleeper. Corresponding mounting kits available for purchase as well! Dyna-Tube Extrusion, aerodynamic radius corner shape, high strength — low weight.
Description: 3D Printer Mini Kossel Delta Robot Fasteners Set Nuts & Bolts Screw Full Kit for 2020 Aluminum Extrusion Frame Note: If you need the fasteners set suitable for 15*15mm aluminum extrusion frame, please check our store. The package list: Cap Screws - (9) m2.5x12 Cap Screws - (78) m3 x 8 Cap Screws - (2) m3 x 10 Cap Screws - (4) m3 x 14 Cap...
This Auction is for a Lot of 10 Minitec 21.1731 , 2 Inch Extrusion Holders. These are used but still usable. Some paint is coming off some but not all of them.
Multiple layer oval leaf filter disc measures 1.5" (short axis) x 3.0" (long axis) and consists of a total of four (4) individual woven stainless mesh screens in an aluminum binder and stacked as follows: 50-100-200-50 mesh. 200 mesh is .007" thick / 100 mesh is .012" thick / 50 mesh is .020 thick Screens were manufactured by Wayne Wire for a now closed...
The Hot Stamping Machine applies foils or pre-printed heat transfers to extrusions at a rate of up to 70 feet per minute. Various extrusion shapes are accommodated by the silicone rubber roller that operates effectively on flat, contoured, and complex extrusion profiles. Multiple units can be configured for increased flexibility, allowing coverage of large areas...
Hand Held Metabo Extrusion Welder, welds PVC, PE, PP . This welder is approximately one year old but only used for a few jobs,( less than 10). Its Ideal for the small shop or occasional jobs or site visits.
A 1994 Techne graham extrusion blow molder model 500S Serial 19100-94. This machine has been thoroughly looked over by our tech and put to power and ran a dry cycle which can be viewed on line at youtube.Specs:4 Head with 80 mm centersContineus extrusionIn machine de-flasher Dry cycle time: 1.8 SecsClamping force : 90 KNwe
One used Conair Metaplast Extrusion Puller, Model PB 2-18, Low gear 28 fpm High Gear is 285 fpm, Motor is 230 volt 12amp 1 Phase. We are Cleveland Process Equipment and specialize in the sales of used Pharmaceutical, Chemical And Plastic machinery. All auctions are subject to prior sale.
Adjustable tension roll for plastic extrusion sheet In good condition and was decommissioned off of a running extrusion line. If you have any additional needs, we can probably take care of them. From drives, motors, and electronics equipment to full extrusion lines we have what you need.
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.