load plate for sale, brand-new and used.

caster

 

2' x 4' Diamond Plate Panel About this item

Used Set of FOUR (4) NOELTING-FAULTLESS Industrial 3" Ball Bearing Swivel Caster Wheels in VERY GOOD Used Condition. Made in Evansville, Indiana, USA. Wheels are made of hard rubber and are 3" diameter X 1-1/4" wide.

REXROTH SANDWICH PROPORTIONAL PRESSURE CONTROL VALVE (ZDC 10 P-2X/M) Rexroth Meter-in pressure compensator, direct operated; ZDC 10 P-24/M Model: ZDC 10 P-24/M aka ZDC10P2XM MNR: R900488023 Valves of type ZDC are direct operated meter-in pressure compensators of 2- or 3-way design. They are used for load compensation as meter-in pressure compensator in channel P. – Sandwich plate valve

This E.R. Wagner plate caster has a polyurethane on aluminum wheel, a flat base with holes for bolting or welding to an object, and a swivel design to allow movement with a 360-degree change in direction. A total-lock brake simultaneously prevents rolling and restricts swivel movement when the foot-operated lever is depressed.

This E.R. Wagner plate caster has a pneumatic wheel, a flat base with holes for bolting or welding to an object, and a rigid design to allow movement in a back-and-forth motion. The plate caster's pneumatic wheel consists of a soft rubber tread on a three-piece steel hub with zinc plating, and it is fully inflated with air at 50 pounds per square inch (psi).

 

 

Shepherd Hardware 9780 3-Inch Cast Iron Swivel Plate Caster, 250-lb Load Capacity

2008 Kodak Magnus 400 Quantum CTP system in excellent condition !!!!!

[ Hamilton S-CH-83FSB 4000 Lb Load Rating 8 In Dia Swivel Plate Caster

ROWE BC1400 REAR LOAD DOLLAR BILL CHANGE MACHINE For sale is a used Rowe BC-1400 model Bill Changer. The model number is BC-1400 which is the rear load style changer. Most commonly used by car wash and laundries.

THIS MOTOR WAS TAKEN OFF A MACHINE NO LONGER IN SERVICE AND IS IN ECELLENT CONDITION. WHILE ON THE MACHINE WE NEVER DID USE ITS FUNCTION SO THE MOTOR HAS NEVER BEEN RAN WHILE INSTALLED. Leeson Motors Gearmotor-Right-Angle Shaft, 29RPM, 1/6HP, TEFC, 115/230V, AC Product Specifications HORSEPOWER1/6 RPM29 TORQUE IN LBS110 FRAME38 TYPE-FRAME13F60-38F ENCLOSURETEFC AMP2 PHASE1 VOLTAGE115 / 230 OVERHUNG LOAD LBS.235 SHAFT ORIENTATION