shield bag for sale, brand-new and used.

Magnetic shield for photomultiplier. Height is 7 inches, and the diameter is 2-1/4". Perfect for standard 2" phototube.

Product Title Easy Add-on Products

Product Title Easy Add-on Products

3/8 Double Expansion Shield (50 pieces) Features The double expansion shield is used for medium duty applications in rock, concrete and brick. This anchor eliminates high stress points detrimental in fastening into materials of medium hardness. This anchor expands fully, has high gripping power, and is ideal where there are sheer loads or where the bolt is subject to sid

Protects eyes from cutting chips Shield Dimension: 12 x 9" Maximum Reach: 21". Universal arm can be locked at any positions with 3 knobs. Clamp on a shaft or a round bar with 1" diameter or less.

Protects eyes from cutting chips Shield Dimension: 12 x 10" Magnetic base: 2.5x2x2" Universal arm can be locked at any positions with 3 knobs. Permanent magnet with strong power pull 180 lbs. To combine shipping, please purchase all items needed without paying and email us when you are done.

Mechanical Outside Micrometers; Minimum Measuring Range (Inch): 0; Maximum Measuring Range: 1 (Inch); Graduation (Decimal Inch): 0.00010; Thimble: Ratchet; Finish/Coating: Satin Chrome / Heat Shield; Accuracy: 0.000160 (Decimal Inch) Type: Outside

ROYAL CNC Spindle Type Live Center - Point Length : 1-7/8" Morse Taper: 3 MT For All CNC Lathes Features Special spindle-like point extends into needle bearing supported shank. Double-row angular contact bearing in front (single row on 1, 2 and 3 Morse Taper). Permanently lubricated bearings.

ROYAL N/C Quad-Bearing Live Center - Point Length : 1-3/4" Morse Taper: 3 MT 3MT CNC POINT QUAD- BEARING LIVE CENTR-ROYAL For Grinders, Manual Lathes And CNC Lathes

ROYAL Quad-Bearing Live Center - TAPER: 3 MT Point Length : 1-1/16" Overall Length : 6-7/16" 3MT QUAD-BEARING LIVE CENTER - ROYAL For Grinders, Manual Lathes And CNC Lathes

ROYAL N/C Quad-Bearing Live Center - Point Length : 1-1/2" Morse Taper: 4 MT 4MT CNC POINT QUAD- BEARING LIVE CENTR-ROYAL For Grinders, Manual Lathes And CNC Lathes

Mill Guard Flexbar arm permits setting of Visorguard at the correct height and angle for each setup. Flip shield up to load part and down for machining. Special spring-loaded shaft makes shield stay put - no springback.

1pcs Brand New RAMBo 1.2 : RAMPS Pre-Assembled Kit Complete: This is RAMPS 1.4 completely pre-assembled where you will receive all electronic components securely soldered to the PCB, tested & ready for use, one (x1) Arduino Mega 2560 connected to RAMPS, four (x4) Pololu Stepper Drivers w/ heatsinks connected to RAMPS, mechanical endstop switches & wires, one (x1) USB cable. The loose a 4-pin pluggable terminal block, a 24 pin header & a loose 2nd Diode are included.

var itemNumber = window.ebayItemID ?

var itemNumber = window.ebayItemID ?

GoldFasion RAMPS 1.4 REPRAP 3D PRINTER CONTROLLER + Mega 2560 R3 +4 A4988 Drivers

GoldFasion 3D Printer Controller RAMPS 1.4 for Reprap Prusa Mendel Arduino AVR