This Is a Custom Manufactured Accessory Design specificaly for the Hardnge Toolroom Lathe. This will hold the cross slide dead nuts.You can do a simple test for Cross slide movement. with a digital readout grab the tool holder and push and pull on the cross slide.
Can be used instead of GNSS rover rod. Attaching only half of a two piece 2 meters long rod it keeps exact height with GNSS antenna (2.0 meters above ground, measured to antenna bottom) if level and settings in field software are used properly: * "The Big Wheel" is perfect for RTK profiling * 19 x 1 5/8 inch "Big Wheel" * Without Rod (one original "pipe" included as can be seen in photos) * Weighs 3.80 lb (1.72 kg)
By clicking "Accept All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyze site usage, and assist in our marketing efforts.