2 muffler for sale, brand-new and used.

This is a nice reproduction ball muffler for a gas engine. It was cast aluminum and someone has smoothed and polished it. They did a really nice job and would look really nice on your restored engine.

Here is a muffler from a vintage gasoline engine. This collectible gas engine muffler measures about 4-1/2" around and 3" wide with a 1" male pipe thread nipple attached. Looks to be in good condition with only surface rust and some small dents though at some point there has been a 1" x 3/4" bell reducer added.

Here is a vintage muffler that may have been from a snowmobile, tractor, gas engine or antique vehicle. This 9" long x 5" round muffler body has a 1-1/2" inlet flange with two 3/8" bolt holes, one slotted, about 2-11/16" apart mounted at about a 30 degree angle to the main body and a curved 1-1/2" outlet that is about 5" long. There is a 1/4" mounting stud on one end and a hoop approximately half way on the opposite side.

Here is a muffler from a vintage gasoline engine. This collectible gas engine muffler measures about 4" around and is about 3" thick with a 1" male pipe thread nipple attached that is about 4-1/2" long. Looks to be in good solid condition with only surface rust and some pipe wrench marks.

This is an original cast iron ball type muffler for a hit and miss or throttle governed gas engine. These were commonly used on Economy engines and several others. They look and work good on any engine they fit on!

An affordable reproduction ball muffler used on many early small engines. Stop wasting time looking at dented, rusty, used mufflers with big price tags, these are proudly made in the USA just like the originals. The muffler 4 inches in diameter with a 3 inch long inlet and has the inner baffle plate.

Shusher Muffler 103055 1" Pipe Thread I believe this is for a sears Suburban but they were used on some Wheel Horse and Bolens

Norgren MQ004A Coalescing Muffler 1/2" port

Here is a new Gast Vacuum Intake Filter Assembly for the model 1023 Gast pumps I sell here on Ebay. It is made by Gast for your pump. The use of this filter can prolong the life of the vanes in your pump.

Here is an original muffler for a 5hp Hercules or Economy gas engine. The mounting threads are very nice. Most importantly there are NO cracks, breaks, or welds.

Here is a nice original muffler for a Nelson Brothers built engine. It would also look good on many other engines. Check out the pictures.

Fits Models: Exmark Lazer Z Kohler CH25-68543, CH25-68606, CH25-68695 and CH730-0003 Specs: &n

Description Kohler Engine Kohler PA-CH680-3087 Replaces OEM: Kohler: PA-76513, PA-CH68